Omnia MN-RCV3 Reference & Installation Manual page 21

For installations using LCD Keypads:
How to program the remote control buttons using an LCD keypad.
In step 5 in Figure 3.3 on page 7:
1. Enter a [
SECTION NUMBER
2. Place the cursor under the digit of the button or button combination you want
to program using the arrow buttons (see Figure 5.2 on page 20). Enter the
hexadecimal value (0 to F) of the desired option from Table 5.1 on page 21.
3. Repeat step 2 for each button or button combination of the remote control.
4. Press [
ENTER
automatically switch to the next section for the next remote control.
Note: To delete the hexadecimal values (button programming) in a particular
section (401-416), press the [0] button once for every value.
For installations using LED Keypads:
How to program the remote control buttons using an LED keypad.
In step 5 in Figure 3.3 on page 7:
1. Enter a [
SECTION NUMBER
2. Enter the hexadecimal value (0 to F) of the desired option from Table 5.1 on
page 21. After every second digit programmed, the keypad will emit a beep
tone:
First digit:
Second digit:
( - -
BEEP BEEP BEEP
Third digit:
Fourth digit:
( - -
BEEP BEEP BEEP
Fifth digit:
Sixth digit:
( - -
BEEP BEEP BEEP
Seventh digit:
Eighth digit:
( - -
BEEP BEEP BEEP
3. Press [
ENTER
Note: To delete the hexadecimal values (button programming) in a particular
section (401-416), press the [0] button once for every value.
] (401 to 416).
] once the remote control is programmed. The LCD screen will
] (401 to 416).
enter the choice for Button A
enter the choice for Button B
)
enter the choice for Button C
enter the choice for Button D
)
enter the choice for Buttons A+B
enter the choice for Buttons C+D
)
enter the choice for Buttons A+C
enter the choice for Buttons B+D
- - ) Confirmation Beep
BEEP BEEP
].
Omnia 19