Appearance and size Material & color The C961 display is made of ABS and is designed to perform well under -20º to 60 º C. Available colors: Black. Size (Unit: mm) Functions & buttons Functions The C961 offers many functions for your riding pleasure. These Include: Multiple Power levels settings (Mode) Remaining Battery Capacity...
Distance and Odometer (TRIP/ TOTAL) Time Assist walking (slow speed motor assist) Backlight Error codes Interface Power Speed Mode Level Unit Walking Distance Time Unit TRIP Button C961 includes a three button electronic control switch: Power on/off ‐...
Caution: Do not plug in or unplug this display when the power to the unit is on. Avoid collisions Protect the display’s membrane to provide water resistant performance. Do not attempt to reset parameters if the display is not working. Call for service if the C961 display is not working Installation Install the display and button control on the handlebar and...
Walking assist Press and hold to start the walking assist. You will see the walking icon on the display and the motor will move the bicycle or vehicle at 4mph (6km/h). This function is designed for walking alongside only. Please do not use this function when riding. Backlight Press and hold ...
Power Level The display is integrated with the controller to provide several levels of power in Pedal Assist Mode (PAS). Press or to change the levels. The Default range is 0 - 5, where 0 means no output, and 5 means maximum output. The default switch on is level 0.
Error codes When something goes wrong with system, an error code will flash on the display. Check details on attached list. The motor will stop working in the event of an error. Only when the error is gone, will the motor work again. Error Codes: Error code Definition...
Display Settings Preparation Makes sure the connections are good, then power on. Setting Press and hold to turn on the display. Press and hold the and to set the mode. Unit Press to change unit Km or Mile. Press ...
Setting the speed limit To limit the speed range (from 10mph to 32mph (15-50Km/h)), press or to change the limit up or down. Press to save & go to set backlight Backlight Press or to change the brightness (range is 1 to 8). Press ...
Time Press or to change the hour, then press to save & go to the minute setting. Press or to change the minutes. Press to save & exit. The settings go into effect after restart. Advanced setting Press and hold ...
Wheel size setting Press or to change the wheel size. Range from 8 to 32 inch. Press to save & go to sleep time interval setting. Sleep time interval setting Press or to change the time, range from 0 to 60 minutes. Display will sleep and cut off power after no operation on system for the selected time.
Cycles”) warrants that any products bought from Lectric Cycles that are defective in materials and/or workmanship will be repaired or replaced, as Lectric Cycles elects, if such defect appears within the warranty period as measured from the date of delivery from the to the purchaser. The warranty period is 12 months.
Page 15
Lectric Cycles limited warranty does not cover or apply to the following: 1) damage, failure and/or loss caused by refitting, neglect, improper maintenance, competition or commercial purpose, misuse, abuse or accident; 2) damage, failure and/or loss caused by shipping; 3) damage, failure and/or loss caused by improper installation, adjusting or repairing.
Software version This C961 adopts Bafang protocol V4.0, and is only warranted to work with a Bafang controller installed with this protocol. Errors may occur if used with other protocols. ‐ 15 ‐...