How To Access The Browser-Based Utility - Linksys RE3000W User Manual

Linksys Wireless-N Range Extender
How to change the power plug configuration
You can connect the extender's built-in power plug directly to a wall power
outlet. For a desktop or table-top setup, you can also remove the built-in plug
and use an AC cable instead.
To attach the AC power plug:
1. Press the plug release latch, then slide the AC plug off the extender.
2. Slide the clip cover into the slot that held the AC plug, then connect the
AC cable to the power connector.

How to access the browser-based utility

After setting up the extender it is ready for use. If you would like to change
advanced settings, use the browser-based utility.
If the extender has not been set up yet
Using a wired computer:
1. Use the included Ethernet (network) cable to connect your extender to
your computer.
2. Open a web browser. If you have defined a default startup page in
your browser, the extender's User name and Password dialog box will
automatically open. If your browser's home or default page is blank,
enter any valid web address and the extender's User name and Password
dialog box will open.
RE3000W
3. Leave the User name blank, then enter the default password "admin. "
4. Click OK. You are logged in to your extender's browser-based utility.
Using a wireless computer:
1. Locate the extender's wireless network name (SSID). The extender comes
with a pre-configured SSID showing as LinksysExtenderxxxxx in the
wireless site survey of your computer, with xxxxx being the last five digits
of your extender's serial number.
2. Connect your computer to the extender's wireless network. Refer to
your computer's operating system documentation or online help for
instructions.
or
RE4000W
4