Kenwood HD30GB9 Operating Instructions Manual page 58

1 ÷ Multi-control (Up) button:
Pressing the multi-control (Up) button immediately
after the start of playback of audio data (while the
elapsed time is between 0:00 and 0:02) skips to the
beginning of the previous audio data.
Pressing the multi-control (Up) button in the middle of
playback (while the elapsed time is 0:03 or after) skips
to the beginning of the current audio data.
÷ Multi-control (Down) button:
Pressing this button to skip to the beginning of the
next audio data.
÷ Holding the multi-control (Up/Down) button depressed
during pause continues the skipping until the button is
released.
÷ With the Play view, press the
[Menu] view, and select [ SKIP+ FOLDER ] to skip to
the next item or select [ SKIP - FOLDER ] to skip to the
previous item.
To turn off
1
Press and hold the
second.
Viewing the help file (Japanese)
When the application softwares is installed in the PC, the
[Kenwood Media Application] help file is also installed.
[Kenwood Media Application] help file is stored in the [Program
Files] \ [KENWOOD] \ [App], provided that the default
installation destination is not modified.
1
Click on [Start] \ [All Programs] \ [KENWOOD] \
[Kenwood Media Application] \ [Help file].
Caution for disposal
Removing the built-in battery:
Never attempt to disassemble the player unless when disposing
of it. (For the replacement of the built-in battery, contact your
dealer or nearest KENWOOD-authorized service agent.)
1
Set the BATT.ON/OFF switch to [OFF].
2
Using a precision Phillips screwdriver (+), remove
the two screws from the bottom panel of the player.
3
Slide and remove the cabinet on the front of the player.
知識編
/ button to open the
/ button for more than 2
4
Take out the battery.
÷ Lift the opposite end to the circuit board's connectors
so as not to apply an excessive force to the
connectors.
5
Unplug the connectors.
÷ Pull the cables that connect the battery to the
connectors straight in the direction of arrow to
unplug.
6
Attach the cables to the battery and put it in a plastic bag.
÷ After removing the battery, attach the cables to it by
wrapping the cable's connectors with tape, and put
the battery in a plastic bag, etc.
POINT:
÷ Remove the built-in battery after confirming that it is
exhausted completely.
÷ Once the battery is removed, it should not be reconnected to
the circuit board's connectors.
÷ After removal, bring the battery as early as possible to a
dealer who supports the rechargeable battery recycling
campaign.
58
Operating instructions
JA