Miele KFN 8995 SD ED-1 Operating And Installation Instructions page 51

^ Remove the two screws from the top
of the bearing block.
^ Swing the door out to the side, then
lift it up and off.
Refitting the parts:
^ Unscrew bearing block e.
^ Remove cover f.
^ Refit cover f on the opposite side by
turning it 180° and then pushing it in
from the side. Netx, turn the earthing
contact g around and fit it on the
opposite side, too.
Changing the door hinging
^ Fit the spacer bushings at the back
of the bearing block on the opposite
side.
^ Screw the bearing block onto the
opposite side.
^ Pull the grey cover on the bearing
block forwards (1) and push it into
the other side of the bearing block
(2).
51