Miele KFN 14943 SDE ED Operating And Installation Instructions page 61

^ Lift the plugs
bearing bushing in the appliance
door and place it on the other side.
Mounting the bottom door of the
appliance:
^ Remove the cover
front.
^ Pull the cover
^ Screw the adjustment foot at the
bearing pin
out of the door
towards the
off.
completely in.
Changing the door hinging
^ With the assistance of another person,
carefully tilt the appliance backwards
and pull the bearing pin
out.
^ Pay attention to the hinge bushing
^ Loosen the screws
hinge bracket
^ Remove the cover
screw. Attach both to the other side.
^ Screw the hinge bracket
other side with the two outer screws.
Do not use the middle screw; this
allows later alignment of the appliance
door using the outer, elongated holes!
^ Unscrew the bearing part
hinge bracket
screw it into the opposite hole of the
hinge bracket.
^ Now place the cover
side.
^ With the assistance of another
person, carefully tilt the appliance
backwards and insert the bearing pin
into the hinge bracket
below. The groove in the bottom of
the hinge bracket faces forwards.
^ Place the hinge bushing
bearing pin .
^ Put the cover
^ Place the lower door of the appliance
onto the bearing pin
^ Close the bottom door of the
appliance.
down and
and remove the
.
and loosen the
onto the
from the
, turn it 180° and
on the other
from
onto the
on.
from above.
.
61