Gozens 708AA User Manual

Bike Guard 708AA USER MANUAL
1
INTRODUCTION
Bicycles are stolen everywhere and every day no matter they are with or without locks. To protect your bicycle
from being stolen, our Digital RF wireless bicycle alarm system can be your best solution. Once the bike theft
happens, the Bike-Alarm will sound loud beeps to scare the thief away and the Beeper will also immediately
activate an emergency alarm to warn you to check the bicycle and take the necessary actions urgently.
Therefore, with Bike Guard 708AA armed on the bicycle, whenever you want to take a short break in the cycling
journey, there is no need for you to worry about parking your bike nearby.
Product Description
Base Unit
Front Back
2
3
4
5
1
Tag Unit
Back
Front
1
2
3
Product Description
Model Name
Function
Search Range
Alarm Triggered
Base Unit / Tag Unit
Base (M08AM)x1
Battery Type
Battery Life Time on Standby
Beep Audible Level (at 10 cm / 3.9 inches)
Base unit : 61.5x36x11.6mm(2.42x1.42x0.46inch)
Dimension (L/W/H)
Tag unit : 38x120x6.2mm(1.5x4.72x0.24inch)
Package Contents How to apply/wear the Base and Tag units.
Base Unit
708AA
Model Name
1 pc
Base Unit
1 pc
Tag Unit
Batteries CR2032x2
Strap 1
Hook 1

User manual
1 Ring attachment
2 Speaker Sound output
3 Connecting status Show the signal synchronous status between Base and Tag unit
4 Search button Press to search for the Tag unit.
5 Power switch Power ON/OFF
6
6
Battery cover
1
Speaker Sound output
2
Screw Hole
3 Battery cover
Bike Guard 708AA
Alert & Search
0~300m/984ft
Vibration Sensor
Tag (S07B)x1
CR2032
Over 45 days (8 hrs/day)
Base unit : 95 db, Tag unit : 102db
Tag Unit
Page 1
Bike Guard 708AA USER MANUAL
2
GETTING STARTED (Out-of-range Alert)
This section shows how to quickly setup and trigger an alert condition.
1. Insert the batteries into the Base unit and the Tag unit.
a) Slide out (remove) the battery covers on the Base and Tag Units.
b) Insert batteries (included) with the "+" mark facing upward in the battery compartments.
c) Replace the battery compartment covers on both units.
Base Unit
b
On/Off switch
2. Make sure that the Base and Tag units are in close proximity.
3. Turn ON the Power switch on the Base units. The base units will establish a link and begin to
blink synchronously .
4. Shock the Tag unit and the base will beep.
5. Congratulations, now you are ready to
case the alarm is triggeved while installation).
3
Alert
A sensor is bulit-in to detect the vibration, while someone is trying to move your bike, the Bike
Guard will alert you in 3 seconds. The Base&Tag unit will alarm for 5 seconds and repeat alarm
until vibration is stop.
Disarm Alarm:
Under standby mode, turn OFF the Master unit within 1 meters from your bicycle, the Tag unit will
sound "Di-du" to approval disarm. When you hear "Di-du", you have disarmed Bike Guard.
Beep Beep...
Tag Unit
put the Tag unit underneath the bottle cage on a bike
Beep Beep...
Page 2
(in