Century NEO 720 Manual page 10

BUILD PHOTOS
1
Assemble the arms as shown on page 4.
4
Select type of battery connector (not includ-
ed) and solder all ESC and DJI BEC/PMU on
power distribution panel.
7
Install the multi-rotor controller on the lower
frame plate as shown.
10
Take a moment to get an understanding of which wires relates to which connectors and take the lower
frame plate and lay it out.
2
Assemble the lower frame plate and aluminum
threaded arm mounts.
5
It is optional to add a disconnect for the BEC/
PMU for quick removal from the power distri-
bution panel. Photo shows a completed power
distribution board.
8
Insert plastic "T" joints over the aluminum landing
gear tubes and use the set screws and self tap-
ing screws to lock together.
11
Page 10
NEO 720
3
Install the distributing panel hex posts on the
UPPER frame plate. NOTE: lower frame plate
shown.
6
Install the power distribution board in between
the lower frame plate and the upper frame
plate.
9
Make two sets of gear assemblies to complete
the landing gear.