Related Manuals for PNI PNI-ZM101-EV
Summary of Contents for PNI PNI-ZM101-EV
- Page 1 User Manual PNI-ZM101-EV ZigBee -ready Wireless Network Evaluation Board Using the UZ2400 RF chip And the 78K0R/KE3 Microcontroller...
- Page 2 1 SAMPLE APPLICATION Two sample applications are included in this evaluation kit. • RF test program • MAC library sample program: send and receive message. A IEEE 802.15.4 compliant MAC library is included in this evaluation kit. It is a linkable object-code library. “C” source code is provided for both RF test program and MAC library application program.
- Page 3 Line feed 1.1 RF test sample application Two PNI-ZM101-EV boards are required to conduct this test. J5 to J8 is used to setup the board 4 LSB address. Set one unit’s address to 0x0001 and the other unit’s address to 0x0002. Connect PNI-ZM101-EV to PC’s USB...
- Page 4 port or COM port, you shall be the following screen. If not, please push the reset button. 1.1.1 Packet Error Rate (PER) Test To start the PER test, first start the receiver board, the board with short address “0002”, press 2 to initiate the receiver loop back function and in the menu of the transmitter board, the board with short address “0001”, press 1 to setup PER test.
- Page 5 - The number of packets received. - The calculated PER in %. - The maximum and minimum RSSI values in this PER test RSSI is received signal strength indication. For the detail of the RSSI value, please refer UZ2400 RF chip’s datasheet. 1.1.2 Continuous TX / Pseudo Noise The menu item “3”...
- Page 6 • Txext messaging between a coordinator and an end device. The sample application supports one coordinator and up to 4 end devices for text messaging. Connect each PNI-ZM101-EV board to USB or COM port of a PC and open HyperTerminal session for each PNI-ZM101-EV board.
- Page 7 Now you shall find the following message in the hyperterminal, if not, reset the evaluation board.
- Page 8 1.2.1 Designation of a coordinator Now you choose a board to be a coordinator and in the hyperterminal which is connect this board type “C” to enter coordinator mode. When successfully started as a coordinator, the return status shall be 00. The coordinator is ready to accept end device’s association.
Need help?
Do you have a question about the PNI-ZM101-EV and is the answer not in the manual?
Questions and answers