OPERATION
TO ADJUST GAUGE WHEELS (See Fig. 9)
Adjust gauge wheels with tractor on a flat level surface.
=
Adjust mower to desired cutting height (S_e '_,O AD-
JUST MOWER CUTTING HEIGHT" in the*Operation
section of this manual)_
°
With mower in desired height of cut position, gauge
wheels should be assembled so they are slightl_ off the
ground. Install gauge wheel in appropriate hole with
shoulder bolt, 3/8 washer, and 3/8-16 locknut and
tighten securely.
•
Repeat for opposite side installing gauge wheel in
same adjustment hole.
QUAKE
'(
WHEEL
/I
,_..\__//
318-16
LOCKNUT
_,_,_
3/8WA
H
/_----/"'_
GAUGE WHEEL
ii
im
II
TO OPERATE ON HILLS
FIG. 9
TO OPERATE
MOWER (See Figs. 7 and 8)
Your tractor is equipped withan operatorpresencesensing
switch. Any attempt by the operator'toleave the seat with
the engine runningand the attachment ciutchengaged will
shut off the engine_
°
Select desired height of cut.
°
Lower mower with attachment lift control,
•
Start mower btades by engaging attachment ctutch
control°
°
TO STOP MOWER BLADES_ disengage attachment
clutch control
J '&
cAU'T1ON: Do not opera't'ethe mower
i
without either the entire grass catcher,
on mowers so equipped, or the dis-
............ charge'guard in place.
. ...
li_
...............
CAUTION:
Do not drive up or down
I
hills with slopes greater than 15° and
I
do not drive across any slope.
!
•
Choose the slowest speed before starting up or'down
hills.
•
Avoid stopping or changing speed on hills.
•
If slowing is necessary, move throttle control lever to
slower position.
•
If stoppingis absolutely necessary, push clutch/brake
pedal quickly to brake position and engage parking
brake.
°
Move motion control lever to neutral (N) position°
IMPORTANT:
THE MOTION CONTROL LEVER DOES
NOT RETURN TO NEUTRAL (N) POSITION WHEN THE
CLUTCH/BRAKE PEDAL IS DEPRESSED,
°
To restart movement,slowlyrelease parking brakeand
clutch/orake pedal.
°
Slowly move motion controllever to slowest setting,
°
Make all turns slowly.
TO TRANSPORT
(See Figs. 7 and 11)
When pushing or towing yourtractor, be sure to disengage
transmissionby placingfreewheel contro! in freewheeling
position_Free wheel controlis located at the rear drawbar
of tractor.
•
Raise attachment lift to highest position with attach-
ment lift control.
°
Remove retainer spring from freewheel control rod
°
Push control rod in to disengage transmission and
reinsert retainer spring into control rod hole now on
back side of the bracket.
•
Do not push or tow tractor at more than two (2) MPH.
•
To reengage transmission, reverse above procedure,
NOTE: To protect hood from damage when transporting
your tractor on a truck or a trailer, be sure hood ts closed
and secured to tractor. Use an appropriate means of tying
hood to tractor (rope, cord, etc.).
/
//
_DISCHARGE
GUARD
FIG. 10
14
FIG. 11