Page 2
Remove the operation panel on the front of the printer. (3 screws) When doing this, remove the flexible cable that is connected to the operation panel. Flexible cable Remove the front right cover on the front of the printer. (2 screws) Remove the pulley cover (black) that is on the right front part of the printer.
Page 3
7 in its original position. (11) Connect the connector of the auto-cutter unit to the relay printed circuit board as shown in the figure. For JN98901, pass the cord through the hole on the right side of the printer housing.
Page 4
(12) Insert the claw on the right side of the auto-cutter unit into the notch on the printer, then fix it in place with the attached screw (1). For the JN98901, be sure to pass the cable between the metal plate and the pulley cover.