Advertisement
Quick Links
AUTO-CUTTER UNIT INSTALLATION GUIDE
CL-S700 Series Model JN98901/JN98911
CITIZEN is a registered trademark of CITIZEN HOLDINGS CO., Japan.
CITIZEN es una marca registrada de CITIZEN HOLDINGS CO., Japón.
Copyright © 2008 by CITIZEN SYSTEMS JAPAN CO., LTD.
This guide is provided for use by service representatives. Service representatives
install the auto-cutter unit, so notify the supplier who sold it to you.
(1)
Check to make sure that the printer's power switch is turned off then disconnect the
power cord.
(2)
Open the top cover and lift the thermal printhead and sensor arm.
Thermal printhead
(3)
Remove the front top cover from the top
cover. (2 screws)
There is a hook on the front top cover.
Note
Be careful not to bend the hook while
removing the front top cover from the
top cover.
(4)
Remove the cutter attachment cover from
the front top cover that you have removed.
The cutter attachment cutter that
Note
you have removed is used to remove
the auto-cutter unit, so store it
carefully.
Caution
Head open lever
Sensor arm
Sensor arm open lever
Top cover
Front top cover
Cutter attachment cover
Side view
Hook
Advertisement
Related Manuals for Citizen JN98901
Summary of Contents for Citizen JN98901
- Page 1 AUTO-CUTTER UNIT INSTALLATION GUIDE CL-S700 Series Model JN98901/JN98911 CITIZEN is a registered trademark of CITIZEN HOLDINGS CO., Japan. CITIZEN es una marca registrada de CITIZEN HOLDINGS CO., Japón. Copyright © 2008 by CITIZEN SYSTEMS JAPAN CO., LTD. Caution This guide is provided for use by service representatives. Service representatives install the auto-cutter unit, so notify the supplier who sold it to you.
- Page 2 Remove the operation panel on the front of the printer. (3 screws) When doing this, remove the flexible cable that is connected to the operation panel. Flexible cable Remove the front right cover on the front of the printer. (2 screws) Remove the pulley cover (black) that is on the right front part of the printer.
- Page 3 7 in its original position. (11) Connect the connector of the auto-cutter unit to the relay printed circuit board as shown in the figure. For JN98901, pass the cord through the hole on the right side of the printer housing.
- Page 4 (12) Insert the claw on the right side of the auto-cutter unit into the notch on the printer, then fix it in place with the attached screw (1). For the JN98901, be sure to pass the cable between the metal plate and the pulley cover.