Page 1
Roby Powered Stair Climber OWNER’S MANUAL (To Be Retained by Owner) Savaria Corporation Part No. 000686 01-m06-2011...
Page 2
IMPORTANT Ensure that only an authorized Savaria DEALER services the Roby Powered Stair Climber. Under no circumstances is anyone other than a Dealer with Savaria training and authorization to adjust, service or modify any mechanical or electrical device on this machine. Failure to follow this warning can result in safety system compromises or defeat;...
Trained operator Trained operator with specific skill Skilled operator authorized by the manufacturer • The Roby is intended for use by an adult that understands its proper operation as set out in this manual. Part No. 000686, 01-m06-2011 Roby Owner’s Manual...
The chassis (Figure 1/a) is a light skeleton type that includes plastic protection and contains the following components: • Motor • Transmission gears • Tracks • Wheels for fast manual movement on the floor • Electrical • Battery Figure 1 Roby Owner’s Manual Part No. 000686, 01-m06-2011...
Page 7
Steering bar release lever (Figure 2/a) • Battery charger plug (Figure 2/b) • Bipolar electrical connector for the controls on the steering bar (Figure 1/b) • Pushbutton for base forward/backward control (Figure 2/c) Figure 2 Part No. 000686, 01-m06-2011 Roby Owner’s Manual...
Battery charge condition indicator LED (Figure 4/d) • “ON/OFF” key (Figure 4/e) Figure 4 Battery Charger The battery charger recharges the battery after stair climber use and maintains the battery charge condition when the Roby is not being used. Part No. 000686, 01-m06-2011 Roby Owner’s Manual...
Safety clamp locking handwheel (Figure 5/b) Figure 5 Electrical Safety Features The optical indicator displays the maximum gradient (Figure 4/c). Warning and Caution Plates The Roby includes the following warning and cautions plates that are visible during operation: • Fasten safety belts •...
Work Position WARNING The driver must stand behind the stair climber and firmly hold the handle bars (Figure 4/f) while operating the Roby. Part No. 000686, 01-m06-2011 Roby Owner’s Manual...
32° F to 113° F (0° C to 45° C) Humidity Maximum 90% Noise Less than 70 db Vibration The Roby can induce passenger vibration and sound by the following means: - Low frequency and moderate acceleration - Brief exposure cycles for the exposed...
Page 13
Timed start pushbutton 1 second delay (forward/backward) Emergency STOP button On steering bar control panel Signals Battery charge condition indicator LED On steering bar control panel Gradient indicator On steering bar control panel Part No. 000686, 01-m06-2011 Roby Owner’s Manual...
Machine dimensions are shown in Figure 6 below. Figure 6 37.4 in (95 cm) 43.3 in (110 cm) 54.7 in 12.2 in 27.6 in (139 cm) (31 cm) (70 cm) 37.4 in (95 cm) 15.8 in (40 cm) Roby Owner’s Manual Part No. 000686, 01-m06-2011...
3. PROPER AND IMPROPER USE Proper Use The Roby stair climber is designed for the transport of persons in manual wheelchairs on staircases. Proper use of the Roby stair climber includes the features below. Environment Indoor/outdoor Steps Parallel, without coatings Gradient Maximum 35°...
Use on wet surfaces or in the rain Electric installation failure Use on staircases without parallel steps Instability, lateral tilting WARNING Never make modifications to the stair climber. Use the stair climber only as intended. Roby Owner’s Manual Part No. 000686, 01-m06-2011...
4. TRANSPORT Handling A dismantled Roby can be transported manually for short trips or for load/unload operations. Transport the chassis using the handles at both ends (Figure 8/a and b), using two people to lift the chassis. Figure 8 Chassis weight with battery •...
Center of Mass The centre of mass is in the lock position between the steering bar and the chassis (Figure 9/a). Figure 9 22.44 in (57 cm) 6.61 in (17 cm) Roby Owner’s Manual Part No. 000686, 01-m06-2011...
1 Unpack the machine in a warm, dry area. 2 Cut the protective film with a knife; do not break it and consequently scratch or damage the finish. 3 Clean the outside of the Roby. Remove any and all residual packaging and dust. Disposal of Packing Material Dispose of all packing material at a local facility.
Temperature: 32°F to 113° F (0°C to 45°C) • Humidity: Max. 90% Electrical Connection • Connect the battery charger to the Roby (Figure 2/b) and plug the charger cord into a wall outlet. Battery Charger Data • Voltage rating (IN): 120 VAC •...
3 Once the steering bar is locked (Figure 11/a), push the red plastic safety protective cover down onto the post release lever (Figure 11/b). WARNING Ensure that the Roby safety protective cover is in its proper position. In this configuration, the electrical contact outlet is engaged and the steering bar is locked in the work position.
To release the steering bar (Figure 12/a), lift the red plastic safety protective cover (Figure 12/b). Release the red pedal (Figure 13/b) and push the steering bar (Figure 13/a) forward as shown by the arrow (Figure 13/c). Figure 12 Figure 13 Part No. 000686, 01-m06-2011 Roby Owner’s Manual...
(Figure 14/b) and release the emergency STOP button. Figure 14 2 Press either the ascend or descend button on the steering bar and move the stair climber under the wheelchair (Figure 15/a). Figure 15 Roby Owner’s Manual Part No. 000686, 01-m06-2011...
Page 25
(Figure 16/a). Push the metallic central pushbutton (Figure 16/c) and slide the wheelchair clamp assembly (Figure 16/d) up/down on the post until the crossbar is just under the vertical height of the wheelchair handgrips (Figure 15). Figure 16 Part No. 000686, 01-m06-2011 Roby Owner’s Manual...
Page 26
6 Loosen each safety clamp assembly (Figure 17/a) by turning the locking handwheel counter-clockwise (Figure 17/b). Slide the safety clamp assembly horizontally (Figure 17/c) until snug against the wheelchair vertical back support posts. Figure 17 Roby Owner’s Manual Part No. 000686, 01-m06-2011...
Page 27
11 Press downward on the steering bar to activate the manual auxiliary wheels. Maneuver the Roby to the leading edge of either stair-flight to perform a descent or an ascent (see Figure 27 and 30).
Manual Operation on a Level Floor To move or turn in manual mode: 1 Using the steering bar as a lever, raise the front side of the Roby to utilize the manual auxiliary wheels. 2 Move the Roby towards you and turn in the desired direction. Proceed forward in the desired direction.
(gradient above 35°), it is not possible to travel on that staircase. Headrest Adjustment To adjust the headrest (Figure 19/a), remove it and adjust as required using the two Velcro strips (Figure 19/b). Figure 19 Part No. 000686, 01-m06-2011 Roby Owner’s Manual...
Never release your grip on the handle bars while carrying a passenger. The person who uses the stair climber determines the stability of the Roby. To avoid unstable conditions, adhere to the following guidelines at all times. Always place the Roby so that the transported passenger’s shoulders are towards the ascent side.
Page 31
1 With the wheelchair properly attached to the stair climber and the green light lit on the steering bar control panel, put pressure on the steering bar (Figure 20/b) such that the nose of the Roby rises (Figure 20/d) and the manual auxiliary wheels activate (Figure 20/c). Move the machine to the edge of the first stair of the flight (Figure 20/a).
Page 32
2 Press the descend pushbutton until the STOP sticker (on the base of the Roby) is parallel (Figure 21/a) to the edge of the first stair (Figure 21/b). Figure 21 3 Raise the steering bar (Figure 21/c) until the tracks touch the lower step.
Page 33
6 If there is another flight of stairs to descend, follow this step. Push and turn the Roby and place it on the edge of the first stair of the next flight (see Figure 22). Press the descend pushbutton until the STOP sticker (on the base of the Roby) is parallel (Figure 21/a) to the edge of the first stair (Figure 21/b).
Page 34
(Figure 23/b) such that the nose of the Roby rises and the manual auxiliary wheels activate. Guide the machine to the edge of the first stair (Figure 23/a).
Page 35
Hold the steering bar firmly with both hands and do not release your grip. 3 At the last stair, release the ascend pushbutton to stop the Roby when the STOP sticker on the base is parallel with the stair (Figure 24/a and b). Put pressure on the steering bar (Figure 24/c) such that the nose of the Roby rises.
Page 36
5 If this is your final destination, guide the Roby away from the flight of stairs and release the wheelchair as described in the section “Passenger Release”. 6 If there is another flight of stairs to ascend, follow this step. Pull and turn the machine to approach the first stair of the next flight (see Figure 25).
In the event of an emergency stop on a flight of stairs, NEVER release the steering bar. If you lock the Roby, ensure it is stable before releasing your hand grip from the steering bar. If the stair climber stops during an ascent due to a discharged battery, there may be enough power to descend.
2 Pull up on the safety clamp pistons (Figure 27/a) and swing the red lever (Figure 27/b) outwards. Loosen the safety clamp locking handwheel (Figure 28/a). Figure 27 Figure 28 3 Lower the steering bar and reattach it to the chassis. 4 Move the Roby manually. Roby Owner’s Manual Part No. 000686, 01-m06-2011...
(which is equipped with a second hole - Figure 31/b) 90° so that the red hook (Figure 31/c) grasps the horizontal bar from downwards and not laterally. This clamps the wheelchair to the steering bar with the same safety of traditional wheelchairs. Part No. 000686, 01-m06-2011 Roby Owner’s Manual...
Page 40
2 Extract the safety clamp (Figure 31/a) toward the outside (Figure 13/f ). 3 Rotate the safety clamp (Figure 32/a) 90° (Figure 32/b) to the left for the left-side clamp and to the right for the right-side clamp. Figure 32 Roby Owner’s Manual Part No. 000686, 01-m06-2011...
Page 41
6 Lock the safety clamp assembly by turning the handwheel (Figure 33/f ). 7 Lift the crossbar (Figure 33/g) until the point at which the red hook (Figure 33/e) is placed in contact with the horizontal bar (Figure 33/d) is reached. Part No. 000686, 01-m06-2011 Roby Owner’s Manual...
1 Remove the key and the power cable and shut off the power. 2 Unscrew the cover screws and remove the cover. 3 Clean all dust, dirt, and any accumulated grease. 4 Once complete, reconnect the general connector and reassemble the cover. Roby Owner’s Manual Part No. 000686, 01-m06-2011...
3 The LED will be orange while the battery is charging. Wait until the LED is green before unplugging the charger. 4 Unplug the charger from the wall outlet and from the Roby. 5 Use the Roby as per the instructions in this manual.
Unit Does Not Start or Move The following table lists possible causes and solutions in the event that the Roby does not start or move. If the malfunction persists, contact your Authorized Dealer. Competence Level Required: O - Trained Operator...
Need help?
Do you have a question about the Roby and is the answer not in the manual?
Questions and answers