Related Manuals for KTI KS-616F
Summary of Contents for KTI KS-616F
- Page 1 Installation Guide 10/100 Fast Ethernet Switch KS-616F KS-624F P/N:750-0140-001 DOC.000617-KS616F-624F-K -20-...
- Page 2 -21-...
- Page 3 TRADEMARKS CISPR A COMPLIANCE: CE NOTICE -23-...
-
Page 4: Table Of Contents
Features ......................... 2 Specifications ....................... 3 Packing List ......................4 Panels ........................4 Mounting the Switches ..................6 Network Switched Ports ..................7 Pin Assignments of MDI-X and MDI RJ-45 ............ 8 UTP Cables ......................9 UTP Connections ....................1 0 Fiber Connections .................... - Page 5 1. Introduction...
-
Page 6: Features
1.1 Features... -
Page 7: Specifications
1.2 Specifications... -
Page 8: Packing List
2. Installing the Switch 2.1 Packing List 2.2 Panels... -
Page 10: Mounting The Switches
2.3 Mounting the Switches... -
Page 11: Network Switched Ports
3. Making Network Connections 3.1 Network Switched Ports... -
Page 12: Pin Assignments Of Mdi-X And Mdi Rj-45
3.2 Pin Assignments of MDI-X and MDI RJ-45 PIN# MDI-X Jacks MDI Jack 4,5,7,8... -
Page 13: Utp Cables
3.3 UTP Cables CONNECTED DEVICE UTP CABLE USED & MAXIMUM LENGTH 10BASE-T device Cat. 3, 4, 5 UTP (100 meters) 100BASE-TX device Cat. 5 UTP (100 meters) -
Page 14: Utp Connections
3.4 UTP Connections -10-... -
Page 15: Fiber Connections
3.5 Fiber Connections Module Connector type Fiber cable Maximum length 600-T 2 Km 600-C 2 Km 600-SA SM * 15 Km 600-S3 30 Km 600-S5 50 Km 600-JM MTRJ 2 Km 600-JS MTRJ 15 Km 600-VM VF-45 2 Km MM : Multimode fiber cable SM : Single mode fiber cable -11-... - Page 16 -12-...
- Page 17 Standard IEEE 802.3u 100Base-FX Speed 100Mbps Duplex mode Full duplex or half duplex Wavelength 1300nm Fiber Connectors ST, SC, MTRJ, VF45 Fiber cable MM 50/125mm, 62.5/125mm recommended SM 9/125mm recommended -13-...
-
Page 18: Operating Mode
3.6 Operating Mode Device Connected Operation Mode Used Auto-negotiation device Auto-negotiation *2 Non-auto*1 half-duplex device auto-speed-sensing *3, half-duplex Non-auto full-duplex device Not supported *1 Non-auto : non-auto-negotiation *2 determined through auto-negotiation process *3 speed is determined by auto-sensing function DIP SW Position Definition Down Port 1X full duplex, FX-1 full duplex... -
Page 19: Trunking Support
3.7 Trunking Support Port 1, Port 2, Port 3, Port 4, Port 9, Port 10, Port 11, Port 12 -15-... - Page 20 # of Trunks Trunking setting Down Down 1 4-port trunk Trunk : port 9, 10, 11, 12 Down 2 2-port trunks Trunk : port 9, 11, Trunk : port 10, 12 Down Up 1 2-port trunk Trunk : port 9, 11 No trunk Disable trunking # of Trunks...
- Page 21 -17-...
-
Page 22: Led Panels
4. LED Indicators 4.1 LED Panels -18-... -
Page 23: Interpretation
4.2 Interpretation STATE INDICATION POWER No power is supplied to the device. POWER Power is supplied to the device. Link/Act. An active link is established. Link/Act. No active link is established. Link/Act. Blink There are Tx or Rx activities. 10/100M 100Mbps speed is used.
Need help?
Do you have a question about the KS-616F and is the answer not in the manual?
Questions and answers