Download Print this page

FBII MX-500 Installation Instructions

Dual technology motion sensor

FRONT HOUSING

REAR HOUSING AND PCB

Step 1

Separate the sensor housings and remove

Printed Circuit Board (PCB).

Step 3

Wire the sensor.

Tamper

Alarm

TB2

Step 2

Mount the sensor.

•

NOTE:

Step 4

Walk-test the sensor.

Power

TB1

Table of Contents

Need help?

Do you have a question about the MX-500 and is the answer not in the manual?

Page 1 Step 1 Step 2 Separate the sensor housings and remove Mount the sensor. Printed Circuit Board (PCB). FRONT HOUSING • • • NOTE: REAR HOUSING AND PCB Step 3 Step 4 Wire the sensor. Walk-test the sensor. Power Tamper Alarm...
Page 2 CE Notice: MICROWAVE SUPERVISION DETECTION PATTERNS 30’ FCC Notice 20’ 10’ NOTE: least once each year PRODUCT SPECIFICATIONS 10’ Range: 20’ Alarm relay: 30’ 12 m IC Notice 10’ 20’ 30’ 40’ Tamper Switch: 2.3 m (7.5’) LIMITED WARRANTY Power requirements: Frequencies: 30’...