Asus Motherboard P4GE-VM User Manual page 26

6. Bass/Center setting (3-pin BCS1, BCS2) (on audio models only)
These jumpers allow you to select the speaker output for a 6-channel audio
system. Switch the jumpers from the BASS/CENTER (pins 1-2) position to
CENTER/BASS (pins 2-3) position to re-route signals on the internal leads of
the Mic port.
Use the audio driver included in the support CD to install the multi-channel
audio feature.
P4GE-VM
P4GE-VM Bass/Center Setting
This section describes and illustrates the internal connectors on the motherboard.
1. Hard disk activity LED (2-pin IDE_LED)
This connector supplies power to the hard disk activity LED. The read or write
activities of any device connected to the primary or secondary IDE connector
cause this LED to light up.
P4GE-VM
P4GE-VM HDD Activity LED
1-16
®
®
BCS1
BCS2
1 2
(BASS/CENTER) (CENTER/BASS)
TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.
IDE_LED
Chapter 1: Product introduction
2 3
(Default)