Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Fiamm Premium HF flex
Summary of Contents for Fiamm Premium HF flex
- Page 1 Technical manual Fiamm Motive Power ® Premium HF flex...
-
Page 2: Table Of Contents
• The chargers’ technical characteristics. Limitations on use.............3 When producing this manual, Fiamm Motive Power has aimed to provide its information in as simple and precise a Destruction of the equipment........3 manner as possible but cannot assume any responsibility for any misinterpretation. -
Page 3: Limitations On Use
(over a period of 24 hours) to avoid any risk of EnerSys ® hereby declares that the chargers in the condensation causing electrical faults (particularly Premium HF flex range covered by this declaration short-circuits). conform to the descriptions laid down in European Directives Replacement parts Directive 2006/95/EC (Low Voltage Directive): The equipment’s production number must be supplied when... -
Page 4: Introduction
Introduction Introduction Control Panel The Premium HF flex range of chargers enable batteries to This contains the display and the control buttons. Please be recharged from the 3-phase mains supply. The Premium refer to the Chapters on Menus and Use for details of the HF flex chargers can recharge automatically batteries in the information shown. -
Page 5: Menus
Menus The menus provide access to the following functions: The information displayed • View of the last 100 measurements (Memory Menu). The history is presented on two screens. • View of the fault and alarm statuses, etc. (Status Menu). • Charger configuration (Configuration Menu). -
Page 6: Status
The operator can therefore check that the electro-valve is opening correctly. Range Only accessible for chargers of the Premium HF flex 48-72-80V type. This defines the battery charging voltage (48/72V or 48/80V). The information displayed... -
Page 7: Use
Unpacking Factory Configuration The charger is supplied with the following components: The charger is supplied with the following factory • A 2m-long mains cable. configuration: • A 3m-long battery cable. Profile: As per the order • The present instruction manual. Output cable length: Configuration: As per the order... - Page 8 Initiating desulphation before charging Effective charging Desulphation of an unsealed lead/acid battery: A few moments after charging starts, the display shows the various charging details in alternation. • Either starts automatically when the battery is heavily discharged; the length of the desulphating operation is Without With defined by the charger’s electronics.
-
Page 9: Display Of The History Per Charging Operation
The Fill the battery. same information as for manual initiation is displayed (see above). (*): A blocking fault preventing charging from continuing. Technical characteristics of Premium HF flex Units 2004 2006 2008... -
Page 10: Technical Characteristics
European Headquarters: EnerSys EMEA EH Europe GmbH Löwenstrasse 32 8001 Zürich Switzerland Phone: +41 44 215 74 10 Fax: +41 44 215 74 11 EnerSys Ltd Oak Court Clifton Business Park Wynne Avenue Swinton Manchester M27 8FF Phone: 0161 794 4611 Fax: 0161 727 3809 Please refer to the website address for details...
Need help?
Do you have a question about the Premium HF flex and is the answer not in the manual?
Questions and answers