Advertisement
Doorbell and Phone Event Package
For Creating Doorbell and Telephone Ring-based Events
The information contained in this document represents current information and views of Card Access, Inc. as of the date of
publication. Card Access cannot guarantee the accuracy of any information presented after the date of this document's publication.
COPYRIGHT ©2007 Card Access, Inc. All rights reserved. Any previously copyrighted contents contained herein remain the
property of the respective creators.
Card Access, InHome, Wires Not Included, and The Wire Stops Here are trademarks of Card Access, Inc.
Control4 is a registered trademark of Control4 Inc.
ZigBee is a trademark of the ZigBee Alliance.
ELK is a mark of ELK Products, Inc.
CEDIA is a trademark of the Custom Electronic Design & Installation Association.
Other marks may be the property of their respective owners.
_________________________________________________________________________________________________________________________
™
™
Card Access
InHome
Doorbell and Phone Event Package Installation Guide / Wiring Diagram
For Doorbell and Telephone Ring Events in Control4 Projects
InHome
Model Number: IDP10A
Installation Guide / Wiring Diagram
®
In Control4
Home Automation Projects
™
Page 1 of 4
Card Access, Inc.
Advertisement
Table of Contents
Summary of Contents for CardAccess In-Home IDP10A
- Page 1 InHome ™ Doorbell and Phone Event Package Model Number: IDP10A Installation Guide / Wiring Diagram For Creating Doorbell and Telephone Ring-based Events ® In Control4 Home Automation Projects The information contained in this document represents current information and views of Card Access, Inc. as of the date of publication.
- Page 2 ™ Card Access InHome Doorbell and Phone Event Package Installation Guide / Wiring Diagram ® for Control4 Automated Doorbell and Phone Circuits Introduction ® It hasn’t been very easy creating automation events for doorbell rings and telephone calls in the Control4 -automated ™...
- Page 3 3. Using two jumper wires similar in gauge to the existing doorbell ringer circuit, connect pins 1 and 2 on the InHome Wireless Contact Switch to the OUT and NEG terminals ELK-930Doorbell Ring Detector. 4. Using the included adhesive foam, mount the ELK-930 Doorbell Ring Detector to a location near the doorbell ringer/transformer assembly.
- Page 4 To notify Card Access of any breach of the foregoing limited warranty and to obtain warranty service, contact Card Access Customer Support by e-mail to inhomesupport@cardaccess-inc.com or by calling 801-748-4900, extension 15, to obtain a Return Materials Authorization (“RMA”) number and instructions for returning your defective product to Card Access.
Need help?
Do you have a question about the In-Home IDP10A and is the answer not in the manual?
Questions and answers