Download
Share
Print this page
  1. Manuals
  2. Brands
  3. ArtFox Manuals
  4. Light Fixture
  5. Beam 15R extreme
  6. Manual

ArtFox Beam 15R extreme Manual

Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Quick Links

Download this manual
ARTFOX BEAM 15R
EXTREME
P l e a s e re a d t h i s m a n u a l
b e f o re o p e r a t e
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the Beam 15R extreme and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for ArtFox Beam 15R extreme

Summary of Contents for ArtFox Beam 15R extreme

  • Page 1 ARTFOX BEAM 15R EXTREME P l e a s e re a d t h i s m a n u a l b e f o re o p e r a t e...
  • Page 2 Catalogue 1. Installation of computer light. 2. Installation of lamp. 3. Power supply. 4. Connection of control signal line. 5. Corrective maintenance. 6. Cleanly maintenance 7. Warning. 8. Difficulty disposal. 9. Qualification. 10. Channel Function Notice: because the policy of improve the products quality of our company.
  • Page 3 1. Installation of computer light. Using eight M10 size bolts, through making use of bracket that owned by computer light install. Make sure the firmness of installation, in case swing or glide happen when it works. Each weight of computer light is 18.5KG more or less. Before installation, it should be ensure if frame can support the weight.

  • Page 4: Power Supply

    supply. It must cool at least 15 minutes to work again after power supply cut off, or it will induce high pressure discharge, short circuit, and even burn out parts of computer control panel. 3. Power supply Using appropriative plug connect computer light and power main lead. Pay attention to consistent of voltage, frequency and supply source of backboard of computer light.
  • Page 5 supplied along with computer light. Connection of XLR can refer to the list below. Attention: every line should not touch each other or touch plug. Computer light can accept data control signal of DMX512 (1990) format. Control signal connect with panel which earmarked “DIGITAL IN”, then connect socket which earmarked “DIGITAL THRU”...
  • Page 6 fuse in back panel should be checked. Notice: If it need replace, using same spec fuse that earmarked in back panel. In the computer light, circuit board has a 3AT fuse. If the fuse has blown, it need replaced by professional.
  • Page 7 Computer light can’t start. Check fuse of back-panel. Though it shine, computer Check data startup address (see section light don’t accept dictate of check connection control. communication control line (see section 4). Computer light works only Check fan, if it operate normally. in intermittence.
  • Page 8 Color Temperature: 8000K Life time: 2000hrs Color: 7 color +open, and rainbow effect Gobo wheel: 7 gobos + white, bi-speed forward and reverse rotation speed jitter, water effects. Iris: 5% to 100% with Iris effect Beam angle: 4-30 degrees Prism:8 face prism, bi-speed rotation effects. Strobe: Monolithic,0.3-13 times / s high speed strobe effect adjustable.
  • Page 9 CH4: Tilt fine CH5: X/Y speed CH6: Dimmer CH7: Strobe CH8: X/ Y auto program CH9: Color CH10: Gobo CH11: Gobo rotation CH12: Prism CH13: Prism rotation CH14: Zoom 1 CH15: Zoom 2 CH16: Focus CH17: Lamp control CH18: Reset...