Advertisement
CAUTION!
Keep this device away from rain and moisture
Unplug Mains lead before opening the housing
Make sure of the voltage on your end in suitable for the unit
For your own safety, please read this user manual carefully before you initially start
Any person involved with the installation, operation and maintenance of this device
Any person involved with the installation, operation and maintenance of this device
has to
- Be qualified
- Follow the instructions in this manual
1. INTRODUCTION
Thank you for having chosen the AVE Vaperiza range. You will see you have
Thank you for having chosen the AVE Vaperiza range. You will see you have
acquired a powerful and versatile device. Unpack your item. Before you initial
acquired a powerful and versatile device. Unpack your item. Before you initial
start-up, please make sure that there is no damage caused by transportation.
up, please make sure that there is no damage caused by transportation.
Should there be any, please consult your dealer and do not attempt to use the
please consult your dealer and do not attempt to use the
device.
2. SAFTEY INSTRUCTIONS
If the device has been exposed to drastic temperature fluctuation (e.g. after
If the device has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The arising condensation
transportation), do not switch it on immediately. The arising condensation
water might damage your device. Leave device switched off until it has
e your device. Leave device switched off until it has
reached room temperature. Always plug in the power plug last. Make sure
reached room temperature. Always plug in the power plug last. Make sure
that the power-switch is set to the OFF position before you connect the
switch is set to the OFF position before you connect the
device to the mains. Never let the power-cord come into contact with other
cables. Handle the power-cord and all connections with the mains with
cord and all connections with the mains with
particular caution. Make sure that the available voltage is not higher then
particular caution. Make sure that the available voltage is not higher then
stated on the rear panel. Make sure that the power-cord is never crimped or
damaged by sharp edges. Check the device and the power-cord from time to
time. CAUTION! Before filling the machine disconnect from mains. Never drink
time. CAUTION! Before filling the machine disconnect from mains. Never drink
fluid or use it on the inside or outside of a human body. If fluid gets in contact
fluid or use it on the inside or outside of a human body. If fluid gets in contact
with skin or eyes, rinse thoroughly with water. If it is necessary call a doctor
immediately DANGER OF EXPLOSION! Never add flammable liquids of any
immediately DANGER OF EXPLOSION! Never add flammable liquids of any
kind to the fog liquid. Keep minimum distance of 50cm to nozzle. Always
kind to the fog liquid. Keep minimum distance of 50cm to nozzle. Always
disconnect from mains, when the device is not in use or before cleaning it.
disconnect from mains, when the device is not in use or before cleaning it.
Only handle the power-cord by the plug. Never pull out the plug By tugging
cord by the plug. Never pull out the plug By tugging
the power-cord. Keep away children and amateurs. Never leave this device
cord. Keep away children and amateurs. Never leave this device
running unattended
y before you initially start
ntact with other
cord is never crimped or
cord from time to
water. If it is necessary call a doctor
3. STARTING OPERATION
Place the machine on a level surface and remove the cap of the flu
ne on a level surface and remove the cap of the fluid tank to
fill with high quality fog
fill with high quality fog liquid
liquid,
the fluid tank. Loose the nut on top cover to open the top cover, fill the ice
Loose the nut on top cover to open the top cover, fill the ice
container with some ice cubes
container with some ice
cubes,
Firmly insert the remote control plug into the socket on the rear of the
Firmly insert the remote control plug into the socket on the rear of the
machine. Ensure the power switch located a
achine. Ensure the power switch located at rear of the machine is "OFF"
plug the power cord into a 3-
-prong, grounded electrical outlet consistent with
the machine's rated voltage. Tum on the power
the machine's rated voltage. Tum on the power switch
remote control will be "on". Al
remote control will be "on". Allow the machine to warm-up about 4 - 5
minutes. When the warm-up is complete the red lamp will be "off", that
up is complete the red lamp will be "off", that
means the ice low fog machine is ready to emit low fog.
means the ice low fog machine is ready to emit low fog.
To emit low fog, press the rem
To emit low fog, press the remote control red button and hold for the desired
length of time. The machinemay need to reheat after an extended discharge
me. The machinemay need to reheat after an extended discharge
of fog. Note: The red lamp on the remote control willcycle on and off as the
of fog. Note: The red lamp on the remote control willcycle on and off as the
machine reheats to its operating temperature. When not use the machine
machine reheats to its operating temperature. When not use the machine
please tum off the power switch, unplug the power cord from the main,
please tum off the power switch, unplug the po
thenopen the top cover to clear the surplus ice cubes from the ice container
thenopen the top cover to clear the surplus ice cubes from the ice container
and drain the water which the ice cubes dissolved
and drain the water which the ice cubes dissolved
CLEANING THE MACHINE
Cleaning your machine regularly will help reduce costly parts replacement and repair
Cleaning your machine regularly will help reduce costly parts replacement and repai
charges. After every 40 hours of contin
ntinuous operation or when the machine will be idle
for a long time it is recommended to run a cleaning solution composed of distilled
for a long time it is recommended to run a cleaning solution composed of distilled
water through the system to prevent the accumulation of particles.
water through the system to prevent the accumulation of particles.
PROCEDURE:
While unit is unplugged, clean with mild soap and water. Allow sock to dry completely
s unplugged, clean with mild soap and water. Allow sock to dry completely
before reattaching to unit. Empty all fog fluid from the machine and replace with
before reattaching to unit. Empty all fog fluid from the machine and replace with
distilled water in the tank. Plug unit in and allow machine to run as usual. Run unit in a
distilled water in the tank. Plug unit in and allow machine to run as usual. Run unit in a
well-ventilated area until tank is empty. Replace clean sock. Cleaning is now complete
ventilated area until tank is empty. Replace clean sock. Cleaning is now
Unplug and store it in dry place. Remember
Unplug and store it in dry place.
Remember,
years of reliable use. The body of the unit may be cleaned with a dry cloth. Store dry.
years of reliable use. The body of the unit may be cleaned with a dry cloth. Store dr
PLEASE NOTE: All information is subject to change without prior notice.
All information is subject to change without prior notice.
PRODUCT USER MANUAL
PRODUCT USER MANUAL
when the tank is
full,
replace the cap back onto
then cover the top cover and tighten the nut.
switch,
the red lamp on the
complete.
a well maintained machine should provide
Advertisement
