ELECRAFT SP3 Owner's Manual
  1. Manuals
  2. Brands
  3. ELECRAFT Manuals
  4. Speakers
  5. SP3
  6. Owner's manual
ELECRAFT SP3 Owner's Manual

ELECRAFT SP3 Owner's Manual

Hide thumbs

Advertisement

Table of Contents

E
SP3 Speaker
LECRAFT
O
'
M
WNER
S
ANUAL

Introduction

The SP3 is a high-quality, front-facing speaker that complements Elecraft's K-Line both aesthetically and
functionally. It can be used with any receiver capable of driving a 4-ohm load. The speaker is passive (non-
amplified), ensuring no susceptibility to RFI in the present of a transmitted signal. The SP3's custom-built,
wide-range driver has excellent sensitivity and deep bass response.
The A/B switch on the front panel of the SP3 can be used to select one of two mono sources. Further, when used
in conjunction with a second SP3 this switch can be used to select one of two stereo sources. The Elecraft K3
and K3
transceivers take full advantage of this feature, since both provide rich binaural audio effects (AFX), as
S
well as user-adjustable left/right balance between main and sub receiver audio.
Rear-panel input jacks accept either mono or stereo cables, simplifying station wiring. An output jack is
provided for connection to a second SP3. When two SP3s are used, the A/B switch on the first unit controls
source selection for both.
E740273 Rev A, October 9, 2015, Copyright © 2015 Elecraft, Inc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SP3 and is the answer not in the manual?

Questions and answers

Related Manuals for ELECRAFT SP3

Summary of Contents for ELECRAFT SP3

  • Page 1 The A/B switch on the front panel of the SP3 can be used to select one of two mono sources. Further, when used in conjunction with a second SP3 this switch can be used to select one of two stereo sources. The Elecraft K3...

  • Page 2: Specifications

    Specifications Dimensions (see Figure 1) The tilt stand height matches the Elecraft K3 and K3 transceivers, the KPA500 Amplifier and the P3 Panadapter. Allow an additional 2" (5 cm) space behind unit for rear panel connectors. Figure 1. SP3 Speaker External Dimensions.
  • Page 3 INPUT B out to select audio at INPUT A  If you want to listen to both the SP3 and headphones at the same time, be sure your K3 or K3 Configuration menu is set to . This will allow you...
  • Page 4 SP3. INPUT A INPUT B  Set the front panel pushbutton switch on the 2nd SP3 to match the input connection you selected.  Be sure your K3 or K3 Configuration menu is set to . This will allow you to hear the...
  • Page 5 SP3 Schematic...
  • Page 6 Elecraft at the time of original order, are not covered by this warranty. If the Elecraft product is being bought indirectly for a third party, the third party's name and address must be provided to Elecraft at time of order to insure warranty coverage.

Table of Contents