Using The Cell Phone Charger; Dynamo; Ac Adapter; Operation Guide - Midland ER102 Owner's Manual

Model ER102 Owner's Manual

Using the Cell Phone Charger

Using the Cell Phone Charger
Because cell phone batteries vary among different brands of phones, we cannot
specify charging rates or usage time exactly. There are two cellphone charging methods:

1. Dynamo:

Slide the power selector switch to the "OFF" position.
Attach the cell phone to the cell phone connector wire. Then, choose the proper
adapter plug for your brand of cell phone and snap onto the other end of the wire.
Rotate the dynamo crank either clockwise or counter-clockwise at about 2 turns per
second.

2. AC Adapter:

Slide the power selector switch to the "OFF" position.
Attach the cell phone to the cell phone connector wire. Then, choose the proper
adapter plug for your brand of cell phone and snap onto the other end of the wire.
Plug in the AC adaptor into the proper jack on the backside of the unit.
Your cell phone will then begin charging.

Operation Guide

Operation Guide
Turning the ER102 ON and OFF
To turn the ER102 ON, position the power selector switch to your power of choice
(Alkaline or AC/Dynamo).
To turn it OFF, position the power selector switch to the OFF position.

Adjusting the Volume

To adjust the volume, use the VOLUME control knob to adjust the audio to the desired
volume level.

Tuning the AM/FM Radio

Set the function selector knob to either AM or FM position.
Tune to the desired station with the TUNING knob. For best FM reception, fully extend the
telescopic antenna and rotate until reception is clear.
Note: Ensure the volume is at an audible level so you will be able to hear the AM/FM
broadcast.
Page 6 www.midlandradio.com