Advertisement
TrANSmITTEr FrONT & rEAr PANELS
e
q w
DC 24V:
Plug the 24V DC power supply into the unit and connect the adaptor to an AC outlet. Only (1) side of device requires power
q
supply when both Transmitter and Receiver obtain PoC function.
LINk LED:
This LED will illuminate when the devices are connected with a CAT5e/6/7 cable from the Receiver side. When the data
w
transmission occurs with errors, the LED will blink.
Power LED:
This LED will illuminate when the devices are connected with power supply.
e
CAT5e/6 OuT:
Connect to the Receiver unit with a single CAT5e/6/7 cable for transmission of all data signals.
r
RS-232 IN:
Plug the 3.5Ø to D-Sub 9-pin female cable included in the package and connect to a PC or laptop for RS-232 commands
t
transmission.
IR2 EXTENDER:
Connect to the supplied IR Extender cable for IR signal reception. Ensure that remote being used is within the direct
y
line-of-sight of the IR Extender.
IR1 BLASTER:
Plug the IR Blaster included in the package for IR signal sending from the Receiver side.
u
HDMI IN:
Connect with source equipment such as DVD/Blu-ray player.
i
rECEIvEr FrONT & rEAr PANELS
e
q w
DC 24V:
Plug the 24V DC power supply into the unit and connect the adaptor to an AC outlet. Only 1 side of device require power
q
supply when both Transmitter and Receiver obtain PoC function.
LINk LED:
This LED will illuminate when the devices are connected with a CAT5e/6/7 cable from the transmitter side. When the data
w
Transmission accrue with error the LED will be blinking.
Power LED:
This LED will illuminate when the device is connected from the transmitter with power supply.
e
CAT5e/6 IN:
Connect to the Transmitter unit with a single CAT5e/6/7 cable for transmission of all data signals.
r
RS-232 OuT:
Plug the 3.5Ø to D-Sub 9-pin male cable included in the package and connect to the device that is to be controlled by
t
RS-232 commands.
IR1 EXTENDER:
Connect to the supplied IR Extender cable for IR signal reception. Ensure that remote being used is within the direct
y
line-of-sight of the IR Extender.
IR2 BLASTER:
Plug the IR Blaster included in the package for IR signal sending from the Receiver side.
u
HDMI OuT:
Connect to a HDMI equipped TV/monitor for display of the HDMI input source signal.
i
r
t
r
t
OPErATION CONTrOLS & FuNCTIONS
y
u
y
u
3
i
i
Advertisement
