Installation - M2 MC2125PALS Service Manual

3. INSTALLATION

Disassemble the refrigerator
● ●
1)
1) With the door closed, disassemble screw(①) by
using (+) screw driver and then disassemble the
upper hinge cover(②).
2) Disassemble bolts (③) and screws (④) to the
counter-clockwise by using a tool, and take off the
upper hinge (⑤) along the arrow (⑥). Take care
when you disassemble the door to ensure that it does
not fall on you.
3)
3) Disassemble the door from the lower hinge (⑦) by
lifting the door (⑧).
4) Disassemble the lower hinge (⑨) from the bracket
lower hinge (⑩) by lifting the lower hinge (⑨) in the
direction of the arrow.
1) To protect refrigerator in movement
Use padded hand truck as shown. If entrance width is
less than 30 〃 , remove doors prior to installation and
reattach doors according to procedure below.
2) Remove all protective tape and pad in refrigerators.
Please adjust the clearance between the doors.
3) Set the temperature control to the temperature and
wait for an hour.
The refrigerator should get slightly chilled and the motor
runs smoothly.
4) Once the refrigerator temperature is sufficiently cool
You can store food in the refrigerator. After starting the
refrigerator, it takes a few hours to reach the appropriate
temperature.
2)
4)
Assemble the refrigerator
● ●
1)
1) Insert the lower hinge (①) in the bracket lower
hinge (②).
2) Assemble the door (④) in the lower hinge (③).
3)
3) Insert the upper hinge shaft (⑤) into the hole (⑥). After
leveling between the upper hinge hole (⑦) and the
hole of the refrigerator (⑧), assemble bolts (⑨)
and screws (⑩) to the clockwise by using a tool.
4) Put the front part of the upper hinge cover (⑪) on the
front part of the upper hinge (⑫) and assemble,
starting with the front part of the upper hinge
cover. Assemble the screw to the clock wise by
using a tool.
9
2)
4)