1. Manuals
  2. Brands
  3. Kellys Manuals
  4. Exercise Bike
  5. MTB
  6. Owner's manual

Kellys MTB Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

OWNER'S

Advertisement

Table of Contents
loading

Summary of Contents for Kellys MTB

  • Page 1 OWNER'S...

  • Page 2: Stem And Handlebars

    Move the lever of the quick-release to the sides only, to positions OPEN or CLOSE. Do not turn thank you for purchase of KELLYS bicycle. We strongly encourage you to read the owner’s manual first locked quick-release lever, it could get damaged! to enjoy your bicycle and for safety reasons too.
  • Page 3 owner‘smanual...
  • Page 4 owner‘smanual mainly after ride in wet and muddy conditions. B.b.parts must rotate without any friction and loose Torque tightening values: Stem sleeve screw M6 20 Nm* if not we advise you to contact a special bike service. Handlebars sleeve screw M6 20 Nm* HEAD PARTS *Recommended values must be kept if instruction on product does not vary.

  • Page 5: Rear Derailleur

    owner‘smanual WARNING • UPPER LIMIT ADJUSTMENT Before ride, make sure that the fork is turning easily, but without a loose, in the head set. Shift on the biggest sprocket. Set the guide pulley into the middle position under the biggest sprocket by turning the low adjustment screw (L).

  • Page 6: Brake Cables

    owner‘smanual system adjustments until it is really necessary! Check periodically the wear of friction surfaces, • UPPER LIMIT ADJUSTMENT brake pads and keep rims clean. Untuned brake system has to be adjusted again or ask a special If the chain falls down from the biggest chainring - the chain guide is too far from the bike frame. bike service for help.
  • Page 7 owner‘smanual SET UP OF BRAKE LEVER POSITION - DISTANCE 1. Release the safety nut of the adjustment screw on the brake lever. If it is necessary to bring the pads There is regulation screw inside of brake lever for distance set up between brake lever and closer to the rim, turn the adjustment screw counterclockwiseout from the thread.

  • Page 8: Front And Rear Wheel

    owner‘smanual DISC BRAKE CLEANING on side of rim. Bent side area of rim is mark of wear which causes self-acting braking. Riding on bicycle with such damaged rims is dangerous and damaged rim must be replaced! Disc brake rotor, pads and brakes must be kept clean. Grime rotor by oil or by other lubricant must be cleaned immediately e.g.

  • Page 9: Rebound Damping

    owner‘smanual unit clockwise (when looking on fork from bottom). To increase fork return speed (marked by “-“) SUSPENSION FORK turn setup unit counterclockwise. Too slow rebound damping could cause that fork is not able to If bicycle is equipped with suspension fork respect following instructions: “copy”...

  • Page 10: Damper Maintenance

    Enjoy your ride! Never exceed maximum pressure values inscribed on damper! KELLYS Never open damper! Visit special cycle service if there are suspicions about proper damper operation, oil leakage, damper loosing ability to absorb blasts or damper makes strange noises while loaded.

  • Page 11: Warranty Conditions

    • The bicycle will be registered in the system of the company KELLYS BICYCLES s.r.o. on the • common wear of rubber parts of the bicycle (tires, inner tube, brake pads, rubber seals);...
  • Page 12 - the dealer is entitled to decide, weather the claim will be admitted and how it will be settled. This above-standard prolonged warranty period is a voluntary act of the company KELLYS BICYCLES s.r.o. and any regulations of Civil Code or other commonly established legal enactments refer to it, but exclusively the conditions listed in this certificate of warranty, in the chapter „Prolonged warranty for bicycle frame“...

Table of Contents