Airstream 360 XL Owner's Manual page 83

AIRSTREAM 390/396 XL
MOEN FAUCET CARTRIDGE REPLACEMENT
CAUTION
: Always turn water OFF before removing existing faucet or disassembling the valve.
Open faucet handle to relieve water pressure and ensure that complete water shut-off has been
accomplished.
1. Remove plug button (3) from the handle by prying the button upwards from the bottom center. Be
careful not to scratch the handle. Lift the handle up and using a 7/64" hex wrench, remove set screw (2).
Remove handle (1), unscrew dome and pivot retainer (4 & 8), cartridge screw (5), handle adapter &
connector assembly (6 & 7), and pivot stop (9). Remove DD washer (IO) and retainer nut (II).
2. Using a flathead screwdriver, remove the retainer clip (14).
3. Grasp cartridge stem with pliers and pull cartridge (15) straight up and out of valve body.
4. Reinstall as follows: Install cartridge (15) into valve body with notched flat on stem facing forward. Be
sure to position the ears of the cartridge in the front and back. Reinstall the retainer clip (14), which
straddles the ears on the cartridge. Reinstall the retainer nut (11) and pivot stop (9) with the stop in front as
shown in Step 4 above. Reinstall DD washer (10) and reassemble handle connector and handle adapter (6
& 7). Note orientation of this sub-assembly as shown in Step 4. Install cartridge screw (5). Be sure to install
completely to prevent unwanted closure of faucet. Thread on dome and pivot retainer (4 & 8) clockwise
until hand tight. Reinstall handle (1), set screw (2), and plug button (3).
G-21