Tion 2; Removing And Installing License-Plate Carrier; Removing And Installing License-Plate; Carrier - BMW 2013 S 1000R Rider's Manual

Removing and installing
5
license-plate carrier
84
Removing license-plate

carrier

Make sure ground is level and
firm and park motorcycle.
Removing passenger seat
( 60).
z
Remove cable tie arrow and
separate connector 1 for
license-plate carrier.
If the license plate car-
rier is removed for race-
track use, the vehicle's electronic
monitoring system will interpret
this as a defective lamp or bulb
and the corresponding warn-
ing message will appear in the
display. This warning message
is suppressed by activating the
EQIP WARN LAMP
SETUP MENU
the .
Thread out connector 1 with
cable through lower rear sec-

tion 2.

with anti-theft alarm system
(DWA) OE
Unplug connector 1 for anti-
theft alarm system.
Before the connector
for the anti-theft alarm
system is disconnected, it
must be ensured that the DWA
has been deactivated in the
SETUP MENU
function in
Remove screw 4.
Remove anti-theft alarm
system 2 while unhooking at
bracket 3.
Disconnect connector 1 for
license-plate carrier.
Remove body-bound rivet 2.
Remove bracket 3 for anti-theft
alarm system.
.