HelloDevice PS100 Quick Start Manual

PS100
www.sena.com

3. Assign IP address

Factory default IP mode setting of the PS100 is
DHCP servers for your network environments, skip this chapter.
1) Select menu at the main menu.
2) Select submenu . Change IP mode to
3) Select submenu 2~6 to set IP configuration parameters according to
your network environment, i.e.
4) Return to the main menu by press key.

4. Serial port configuration

1) Select the menu
menu.
2) ) Select the menu .
3) Select the submenu
host mode parameters according to your application.

1. Connection

1) Hook up the power to the
HelloDevice PS100.
2) Hook up the Ethernet cable to
the RJ45 connector of the
HelloDevice PS100 with your
hub or switch.
3) Hook up the RS232 serial cable
between the HelloDevice PS100
and your serial device.
(See Table 1 for pin assignments)
4) Turn on the power switch of the HelloDevice PS100.
5) ) Confirm the
6) Confirm the
up and
is blinking.
1 2
6
4) Select the submenu
those of your serial device.
. If you are using
5) Return to the main menu by press
.
.

5. Apply changes

1) After finishing the serial port configuration, return to the main menu
by pressing
2) Save changed values by selecting menu
main menu.
3) Reboot the HelloDevice PS100 by selecting menu
at the main
, and set up the
Figure 1. Connecting power
Figure 2. Connecting Ethernet cable
Serial Device
Figure 3. Connecting serial device
LED lights up on the front panel.
LED lights
Pin RS232 RS422 RS485
LED
1 Tx- Data-
2 Rx
Tx Rx-
3
4 DTR Rx+
3 4 5
5 GND
DSR
6
RTS
7
CTS
8
Tx+ Data+
9
7 8 9
Table1. DB9 Pin assignments
, and set up the parameters as same as
key.
key several times.
at the
.

2. Log-in to serial console

1) Connect a null-modem serial cable
between your computer and the
console port of the HelloDevice PS100.
Figure 4. Connecting console cable
2) Run a terminal emulation program such as HyperTerminal and set up
the serial configuration parameters as follows:
3) Press key at the terminal emulation program.
4) Enter the user name and password. Factory default settings of the
user name and password are both .
U.S. / Canada / South America
Tel : +1 (408) 573-7425 Fax: +1 (408) 907-3738
EU / Africa
Tel : +33 (0) 1 53 53 16 29 Fax: +33 (0) 1 70 24 70 90
Asia / Pacific
Tel : +82-2-571-8283 Fax: +82-2-573-7710
Contact us via E-mail
General Information : info@sena.com
Sales & Distribution : sales@sena.com
Technical Support : support@sena.com
www.sena.com