Subscribe to Our Youtube Channel
Related Manuals for ViSAGE FCM1000
Summary of Contents for ViSAGE FCM1000
- Page 1 Foot and Calf Massager Model Number: FCM1000 INSTRUCTION MANUAL AFTER SALES SUPPORT customercare@winplus.com.au 1300 663 907 MODEL: FCM1000 PRODUCT CODE: 47893 12/2014...
-
Page 3: Welcome
Congratulations on choosing to buy a Visage product. ® All products brought to you by Visage® are manufactured to the highest standards of performance and safety, and, as part of our philosophy of customer service and satisfaction, are backed by our comprehensive 1 Year Warranty. -
Page 4: Table Of Contents
Welcome Warranty Page General Information and Safety Instructions Features / Technical Specifications Assembly and Parts List Getting Started Instructions Index Repair & Refurbished Goods or Parts Notice AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907... - Page 5 You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. AFTER SALES SUPPORT customercare@winplus.com.au YEAR WARRANTY 1300 663 907 MODEL: FCM1000 PRODUCT CODE: 47893 12/2014...
-
Page 6: General Information And Safety Instructions
• The supplier is not responsible for the end use of this product including any improper use or when used for purposes that are not specified. AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907... - Page 7 Do not sit on the Foot and Calf Massager. Do not use the Foot and Calf Massager if the fabric is torn or damaged. AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907...
-
Page 8: Features / Technical Specifications
• Carry Handles Technical Specifications Model Specification: FCM1000 Voltage: 220-240VAC ~50Hz Power: 80-110W Heat Settings: 3 Foot Massager Settings: 3 Calf Massager Settings: 3 Weight: 11kg Warranty: 1 Year AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907... -
Page 9: Assembly And Parts List
Assembly and Parts List (Located at Back) Height Adjustment Bar (below) Rubber Feet Leg Slots Power Connection Control Panel Power Switch/Fuse Slot Carry Handles (both sides) Power Cord Removable Covers AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907... -
Page 10: Getting Started
WARNING: Do not connect the power in or near wet areas. AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907... - Page 11 Press the Heat button to operate the Heating element. Choose HEAT between Modes: “I”, “II” or “III” being the hottest. NOTE: When using the heat mode, allow a few minutes for the element to heat up. AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907...
-
Page 12: Instructions
ON/OFF button once to turn off and allow the massage cycle to finish. NOTE: The Foot and Calf Massager will automatically go into stand by mode after 15 minutes of use. AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907... - Page 13 • Do not turn the unit off at the power point during use or pull out the power cable; this may prevent the massage cycle from completing, making it hard to remove your legs. • Manoeuvre your legs during use to find a comfortable position. AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907...
-
Page 14: Cleaning And Storage
Storage Always store the Foot and Calf Massager in dry covered areas. Never store in damp humid areas, or in direct sunlight. AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907... - Page 15 Slide the fuse holder out from between the power switch and power connection. Replace with a 5A fuse*. Slide the fuse holder with the new fuse back into the slot. *5A fuse not included AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907...
-
Page 16: Faq
The Foot and Calf • The unit is designed to go into standby mode after 15 minutes of operation. Massager automatically turns off during use AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907... - Page 17 Notes AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907...
-
Page 18: Index
4, 5, 6, 8, 9, 10, 11, 12, 13, 14 Power Connection 7, 8, 13 Power Switch 7, 10, 12, 13 Removable Covers 6, 7, 12 Technical Specification Warnings Warranty Page Welcome AFTER SALES SUPPORT customercare@winplus.com.au MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907... -
Page 19: Repair & Refurbished Goods Or Parts Notice
Winplus Australasia PO BOX 537 Bayswater Business Centre Bayswater, VIC 3153 Winplus Help Desk 1300 663 907 (Operating Hours: Mon-Fri 08:30AM to 6:00PM) customercare@winplus.com.au www.winplus.com.au customercare@winplus.com.au AFTER SALES SUPPORT YEAR WARRANTY MODEL: FCM1000 PRODUCT CODE: 47893 12/2014 1300 663 907...
Need help?
Do you have a question about the FCM1000 and is the answer not in the manual?
Questions and answers