Related Manuals for Joemeek Three Q
Summary of Contents for Joemeek Three Q
- Page 1 THREE Joemeek User Guide v i s i t u s o n t h e w e b a t j o e m e e k . c o m...
-
Page 2: Table Of Contents
Contents The Next Generation of Joemeek studio processors represents a quantum leap in the history of the Joemeek legend. Long regarded for its “Big Sound”, threeQ Controls at a Glance..........5 the original Joemeek gear was both revered and reviled for its somewhat “quirky”... -
Page 3: Threeq Controls At A Glance
threeQ Controls at a Glance PREAMP GAIN - sets the amount of audio amplification. Too little gain MID - controls the middle frequencies in the audio spectrum. 15dB of and the sound will be too quiet; too much and the signal could become boost or cut is available at the selected frequency. -
Page 4: Overview
Gain control is rather uneven, with the 40dB to 60dB range being crammed Joemeek products approaches this limit. To improve significantly on into the last 1/6th of a turn. All Joemeek preamps use a specially designed this would require highly specialised electronics and probably a vat of control that ensures smooth operation over the whole range of rotation. -
Page 5: Compressor
1:1. As the compressor is driven harder, the ratio rises to 5:1, at How the compressor behaves actually changes with programme con- least up to a point. It is a feature of the Joemeek compressor that the com- tent and volume. So experiment with the controls with different kinds... -
Page 6: Meequalizer
This is a jack on the rear panel, which allows you to connect a second audio this is relative to the selected operating level of “+4dBu” or “-10dBv”. In source (for example another Joemeek threeQ!) The Mix input comes after other words if you have selected “4dBu” and the meter reads “0”, then the threeQ’s Preamp, Compressor and Meequalizer, but before the Output... -
Page 7: Using The Threeq
Using the threeQ GETTING CONNECTED • A microphone is connected to the Mic Input The figure shows the threeQ being used instead of a mixing desk • An additional source is being fed into the Line Input in a recording setup •... -
Page 8: Troubleshooting
Troubleshooting 5) Too little or too much compression • Turn the ‘Input Gain’ control up or down respectively, to adjust the 1) No Power (no lights work) signal level to the compressor • Is the power supply plugged in (both ends)? •... - Page 9 Notes Joemeek Limited Warranty THIS PRODUCT IS FOR PROFESSIONAL USE ONLY replacement by Purchaser of any Product or part thereof shall extend the warranty period as to the entire Product. The specific warranty on PMI Audio Group warrants that all products will be free from defects in mate-...
- Page 10 Owners Registration Card Disclaimer of Warranty T O B E C O M P L E T E D AT T I M E O F P U R C H A S E EXCEPT FOR THE FORGOING WARRANTIES, PMI HEREBY DISCLAIMS AND EXCLUDES ALL OTHER WARRANTIES, EXPRESS OR LIMITED, INCLUDING, BUT Name _____________________________________________ NOT LIMITED TO ANY/OR ALL IMPLIED WARRANTIES OF MERCHANT ABILITY,...