Page 2
- usually 14.5”. Adjust the brackets to slightly less than the desired dimension. 2.3 - Repeat this procedure on the bottom surface of the loudspeaker. NOTE: ai models have bracket mount screw locations on enclosure sides and front (the same screws that secure the speaker baffle) to facilitate mounting in orientations other than shown here.
Page 3
(tweeter) processing for the model being installed. Be sure to observe correct polarity and connect ONLY to amplifier with DSP programming for your ai model. Connection to an amplifier with incorrect DSP program could result in loudspeaker damage.
Page 4
Installation Guide AFTER CONSTRUCTION IS COMPLETE Step 6 - Reinstall Baffle Assembly 6.1 - Remove the #10-24 machine screws installed in the enclosure front. 6.2 - Reconnect the white wire harness connector. 6.3 - Reinstall the baffle assembly and secure it using the #10-24 machine screws. Tighten screws uniformly to insure an air-tight seal between baffle and enclosure.