Printed Wiring Board Diagrams - Sanyo MS6A Service Manual

Printed Wiring Board Diagrams

Power Board (SIDE:A)
FN902
FN904
FN903
Main
Board
"K8R"
Lens
Motors
Main
Board
"K8S"
P.F. Board (SIDE:A)
Lamp Ballast Unit "CB1" Interlock Switch "SW904"
Power
Board
"K6F"
R/C Board (SIDE:A)
Main Board
"K8G"
A12
CAUTION
This projector is isolated from AC line by using the internal converter transformer.
Please pay attention to the following notes in servicing
1. Do not touch the part on hot side (primary circuit) or both parts on hot and cold sides (secondary
circuit) at the same time.
2. Do not shorten the circuit between hot and cold sides.
3. The grounding lead must be connected to the ground of the same circuit when measuring of volt-
ages and waveforms.
P.F. Board "K6E"
Line Filter Board (SIDE:A)
SW902
SW904
LF901
Power Board (SIDE:B)
P.F. Board (SIDE:B)
R/C Board (SIDE:B)
Line Filter Board (SIDE:B)
PCB_MS6A