i-Flash P2DIR User Manual page 22

i-Flash Technology Limited
Rm 1110, 11F, Fabrico Industrial
Buildings, 78 Kwai Cheung Road,
Kwai Chung, NT. Hong Kong
Register DIR to a SIP Server
1. From the DIR home page, click Basic Settings > SIP.
2. Go to SIP Settings Tab.
3. General Phone Settings.
Registered – The field shows the registration status of the account with the SIP server.
Unregister On Reboot – If it's checked, the SIP user's registration information will be cleared
from the server when the phone reboots.
4. Enter the required information.
Account Name
SIP Server
Outbound Proxy
SIP User ID
Authenticate ID
Authenticate Password
STUN Server
Stream
Preferred Vocoder
Registration Expiration
Local SIP Port
5. Click Save to save all the changes. You need to restart the device to apply all changes.
PULSE DIR Series Installation Guide
Web: www.iflashtec.com
Tel: +852 2110 9587
Fax: +852 3585 5233
Email: info@iflashtec.com
– The field configures the SIP account name.
– The SIP Server's IP address or Domain name provided by your service
provider.
– The IP address or Domain name of the Outbound Proxy, Media Gateway,
or Session Border Controller. Used for firewall or NAT penetration in
different network environments. If the system detects a symmetric NAT,
STUN will not work. ONLY outbound proxies can provide a solution for a
symmetric NAT.
– User account information provided by your service provider (ITSP); this is
either an actual phone number or is formatted like one.
– The SIP service subscriber's Authenticate ID used for authentication. It
can be identical to or different from the SIP User ID.
– The SIP service subscriber's account password for the GXV to register to
the SIP server of the ITSP.
– If the device is behind a router, a STUN server is needed to help
penetrate the NAT.
– To choose between Primary and Secondary stream.
– To choose different Vocoder type.
– This parameter allows users to specify the time frequency (in minutes) in
which the GXV refreshes its registration with the specified registrar. The
default interval is 60 minutes.
– This parameter defines the local SIP port used to listen and transmit. The
default value is 5060. Local RTP Port – This parameter defines the local
RTP-RTCP port pair that is used to listen and transmit. The default value is
5004.
22 | P a g e