Asus TUEG-VM Motherboard 815EG User Manual page 39

3. HARDWARE SETUP
12) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output. The
connector powers up the system when a wake up packet or signal is received
through the LAN card.
IMPORTANT:
This feature requires that Wake On LAN or PCI Modem is
enabled (see 4.5.1 Power Up Control) and that the system has an ATX power
supply with at least 720mA +5V standby power.
®
TUEG-VM
TUEG-VM Wake-On-LAN Connector
13) Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT:
This feature requires that Wake On LAN or PCI Modem is
enabled (see 4.5.1 Power Up Control) and that your system has an ATX power
supply with at least 720mA +5V standby power.
®
TUEG-VM
TUEG-VM Wake-On-Ring Connector
ASUS TUEG-VM User's Manual
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
WOL_CON
+5 Volt Standby PME
Ground
WOR
1
Ground
Ring#
2
39