Summary of Contents for Eagle power TKS510ET
- Page 1 TKS510ET SILVER SERIES VACUUM SWEEPER OPERATION & MAINTENANCE MANUAL AUGUST 2005 REV A...
-
Page 2: Table Of Contents
OPERATION AND MAINTENANCE TKS510ET SILVER SERIES INDEX General Information and Key ................. Page 2 Security Warning ....................Page 2 Serial Number and CE Marking ................Page 3 Technical Features & Specifications ..............Page 3 Foreword ........................ Page 3 Utilization Field ...................... Page 3 Unpacking the Machine .................. -
Page 3: General Information And Key
OPERATION AND MAINTENANCE TKS510ET SILVER SERIES As the machine is not provided with a parking brake or service brake, GENERAL INFORMATION - KEY pay attention when you are using it on sloping surfaces. Do not leave the machine unattended on sloping surfaces. -
Page 4: Serial Number And Ce Marking
OPERATION AND MAINTENANCE TKS510ET SILVER SERIES In the case in which one of the above mentioned parts is missing, place 1.2 - SERIAL NUMBER AND CE MARKING inform your dealer straight away. Always ensure that the machine is provided with a name plate giving Take care to keep the packaging materials (bags, cartons, the serial number and CE marking in the position shown in Fig. -
Page 5: Preparing The Machine For Operation
OPERATION AND MAINTENANCE TKS510ET SILVER SERIES 1.2 - SERIAL NUMBER AND CE MARKING Distilled water. Battery: Always ensure that the machine is provided with a name plate giving the serial number and CE marking in the position shown in Fig. 1. -
Page 6: Controls
OPERATION AND MAINTENANCE TKS510ET SILVER SERIES you will not be able to operate the key pos. 2 Fig. 3 on the 2.3 - PREPARING THE ENGINE FOR OPERATION dashboard. For more detailed information on the engine Check the level of the oil in the engine. Fill the fuel tank consult the relevant manual. -
Page 7: Preparing The Engine For Operation
OPERATION AND MAINTENANCE TKS510ET SILVER SERIES 4.1 - STARTING 4.2 - CORRECT OPERATION ATTENTION: the machine must be used by authorised personnel only. DO NOT leave the machine UNATTENDED when it is After you have become conversant with the operations required to running. -
Page 8: Routine Maintenance
OPERATION AND MAINTENANCE TKS510ET SILVER SERIES 5.3 - FILTER MAITENANCE Cleaning the filter 5.1 - ROUTINE MAINTENANCE The filter is one of the machine main components. It is essential for the best results from your machine. If you notice that dust forms when ALL ROUTINE MAINTENANCE AND SPECIAL MAINTE- the machine is at work, check the filter. -
Page 9: Replacing And Adjusting The Side Brush
OPERATION AND MAINTENANCE TKS510ET SILVER SERIES 5.4 - REPLACING AND ADJUSTING 5.6 - REPLACING AND ADJUSTING THE BELTS THE SIDE BRUSH To prepare the machine for belt replacement, carry out the following operations: Replacing - remove the top bonnet and the front bin. -
Page 10: Replacing And Adjusting The Flaps
OPERATION AND MAINTENANCE TKS510ET SILVER SERIES 5.7 - REPLACING THE FLAPS - Pull the cable out of the fixing pin and remove the adjusting screw 5.7.1 - Outer side flaps mounted on the handle. To replace the side flaps pos. 1 Fig. 8, remove the rear wheels and the - Press the handle and pull the cable out of its sheath. -
Page 11: Wiring Diagram
OPERATION AND MAINTENANCE TKS510ET SILVER SERIES 6.1.1 - WIRING DIAGRAM 510 ET - 711 ET 6.1.2 - WIRING DIAGRAM 710 ET M1) Main brush motor I1) Key switch M2) Traction motor I2) Fan switch M3) Fan motor Car.Batt) Battery recharge socket... -
Page 12: Warranty
Warranty Policy Limited Warranty Eagle Power Products (EPP) warrants new cleaning equipment against defects in material and workmanship under normal use and service to the original purchaser as detailed below. 10 Years Subject to the conditions stated below, EPP warrants polyethylene tanks and housings to be free from defects in materials and workmanship for a period of ten years.