Table of Contents
Advertisement
3. Pairing/connecting
1) Pairing headset with Bluetooth cell phone
Prior to using the headset for the first time, you have to pair it with a
Bluetooth-enabled cell phone. The pairing procedures are subject to
different models of cell phones. Please refer to your cell phone user's
manual for further information.
The general pairing procedures are as follows:
1) Keep your headset turned off and within 1 meter of phone ;
2) Press and hold about 8 seconds until the red and blue LED flash
alternately, the headset enter into paring mode;
3) Activate your cell phone's Bluetooth function and search for Bluetooth
devices within range, select "K3 TANGO" from the list of devices
shown (enter password "0000 " if the headset prompt);
4) After successful connecting, blue LED of headset flashes twice every 4
seconds
Remarks:
Pairing mode will last 2 minutes, the headset will back to standby mode
u
if the pairing failure. PLEASE NOTE HOLD 8 SECONDS-ABOVE
If the pairing is not successful, turn off the headset and repeat the steps as
u
above.
Every time the headset is turned on, it will connect to last connected
u
device automatically. The headset can remember 8 paired devices, when
the number of paired devices exceeds 8, the first one will be replaced.
2) Pairing headset with a Bluetooth cell phone via NFC
K3 Tango supports NFC Technology; it can quickly connect with Bluetooth
cell phone via NFC. First, activate the Bluetooth and NFC function of cell
phone.
Remarks:
**Please keep the NFC area of cell phone and headset within 1 centimeter
until the red and blue LED of headset flash alternately(First pairing time
maybe 3 seconds). The headset will disconnect when you make the NFC
area of cell phone and headset touch each other again.
5
Advertisement
Table of Contents
