komodo KD42LPFDGFRZA Quick Start Manual

The most reliable portable cooling system in the world.
•
High efficiency, low energy consumption.
•
Multi-voltage system DC (12 and 24 Volt )
•
Adjustable battery protection helps protect your battery (DC only).
•
Warning: Do not use your unit if any cabling is damaged, frayed or there is
•
exposed wiring.
•
Warning: Do not attempt or continue to operate your unit if it is wet.
•
When using unit, ensure the circuit being used has a fuse or circuit breaker.
•
Recommended size for DC 12 Volt is 15 Amp, DC 24 Volt is 7.5 Amp.
Make sure the voltage is within the correct range for socket and cable being used. The
•
technical data label on the side of the unit shows the voltage ranges.
Do not place any electrical devices inside the refrigerator as they may be damaged.
•
Your unit requires good ventilation, especially around the back of the refrigerator; allow a
•
gap of at least 100mm around all sides.
Do not allow a large amount of frost to build up on the inside walls as this may impair
•
cooling. Defrost by turning the unit off, allowing the frost to melt and wiping out the
water.
The lower the ambient temperature, the lower the power usage. In order to maximize
•
efficiency, keep the unit in a cool location out of direct sunlight.
It is recommended to operate the unit on a flat surface, but it will operate at angles up to
•
30°.
Battery Protection: Selecting the Low, Med, High positions of the switch (next to the DC
•
power socket), you can choose different levels for battery protection.
Press the button
•
achieve. Press the
When you press the"SET" buttons, it switches the display between °C and °F.
•
Press the "SET" button to enter economy running mode, the ECO indicator green LED
•
light will be on. Press the button again; the unit will enter the maximum running mode
(HH) MAX indicator red LED light will be on.
The economy mode runs the compressor at a lower speed to save power; the maximum
•
mode runs the compressor at a higher speed increasing power usage. Maximum mode is
useful if the ambient temperature is over 30°C or fast cooling is required.
Plug in the DC power. Press the button ON/OFF to turn the unit on. The LED display on
•
the control panel will turn on and the interior temperature is displayed.
If the power supply is cut off or disconnected, the unit will switch off automatically and
•
once the power supply is restored it will automatically switch back on.
△ ▽
UP or DOWN button to adjust the temperature the unit aims to
△
button to increase or the
▽
button to decrease the temperature.