Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Queen HVA
- Page 1 HVA/HVM USER MANUAL UM_EN Part No.: 1730015_02...
-
Page 2: Table Of Contents
CLEANING AND CARE ........................... 8 ERROR MESSAGES ............................9 PROGRAMMING ............................10 Set machine for manual water filling ......................... 10 DIMENSION SKETCH ..........................11 HVA/HVM ................................11 Some important information may appear in textboxes seen below IMPORTANT! CAUTION! More INFO. -
Page 3: General
GENERAL HVA/HVM Introduction Thank you for choosing a HVA/HVM hot water machine. We hope you enjoy it ! Read the user guide before using the machine. Always keep this guide close at hand for future This guide contains important instructions for reference. -
Page 4: Facts & Weight
GENERAL HVA/HVM Facts & weight FACTS HVA/HVM 1 phase HVA/HVM 3 phase Height, Width, Depth 500, 225, 410mm 500, 225, 410mm Tank volume 7.5 Litres 7.5 Litres Power supply 220-230VAC 1N~ 2200W 50/60Hz 380VAC 3N~6600W 50/60Hz Cold water connection ½” External thread ½”... -
Page 5: Overview Of Components
OVERVIEW OF COMPONENTS HVA/HVM FRONT Hot Water Tap Display Temperature Adjustment Buttons BACK Drip Tray Insert Drip Tray Water Connection Power Switch... -
Page 6: Installation And Start-Up
INSTALLATION AND START-UP HVA/HVM Positioning Place the machine on a flat and waterproof surface that will support the weight of the machine. MIN. 10cm Make sure air is able to circulate behind Note the machine (minimum 10cm). Start-up procedure Connect the supplied water hose to the cold water connection using a ½’’... -
Page 7: Adjusting Water Temperature
INSTALLATION AND START-UP HVA/HVM Adjusting water temperature Adjust water temperature by pressing the buttons on membrane switch. Max temperature 96ºC Min temperature 70ºC Increase the temperature Reduce the temperature Dispensing hot water Place a glass or decanter under the hot water tap.(A) Pull down the tap handle to start dispensing water.(B) -
Page 8: Cleaning And Care
CLEANING AND CARE HVA/HVM Exterior cleaning when necessary To clean the exterior of the machine, use a soft cloth and liquid cleaning agent that is non-abrasive. -
Page 9: Error Messages
ERROR MESSAGES HVA/HVM LEVEL CONTROL Remove the power SHOWN ON THE POSSIBLE POSSIBLE FAULT cord from the wall DISPLAY SOLUTION socket during any installation work. - The high water level - Clean the level sensor. sensor is triggerd - Replace. -
Page 10: Programming
Keep button (B) pressed while turning on the power switch.(D) The display will show T1, change the type of machine with buttons (B) or (C). T1 = HVA automatic T2 = HVM manual Confirm the choice by holding down the buttons (B) and (C) at the same time for approximately 5 seconds. -
Page 11: Dimension Sketch
DIMENSION SKETCH HVA/HVM HVA/HVM Model HVA/HVM 1 phase 500mm 225mm 410mm 240mm 210mm HVA/HVM 3 phase 500mm 225mm 410mm 240mm 210mm... -
Page 12: For Service
For the warranty to be valid the conditions for maintenance must have been followed according to our instructions, proper precaution has been made and warranty claim been issued without delay. The affected equipment may not be used during awaiting service if there is any risk that the damage or defect would worsen.