WALL MOUNTED 500W
PROFESSIONAL
FLOODLIGHT
Floodlight
Cover Clip
Junction Box
Front Surround
Mounting Bracket
SAFETY PRECAUTIONS
The device is designed for outdoor usage.
Do not operate the unit with wet hands or
while standing on a wet or damp
surface.
Avoid operating the Floodlight or leaving
power cord in standing water which may lead
to a fatal shock.
Do not remove the wire guard or tempered
glass while the Floodlight is ON.
Keep away from flammable objects and
handle with care.
If a new glass is replaced, use only tempered
glass of equal thickness.
If an extension cord is needed, a 3 prong
grounded plug must be featured.
Follow strictly the regulations when
connecting the electrical system to this
Floodlight.
Minimum safe distance to flammable areas is
1 M.
IMPORTANT
Some local building codes may require installation
of this product by a qualified electrician.
Check your local codes as they apply to your
situation. If the house wiring is of aluminum,
consult with an electrician about proper wiring
methods.
Before proceeding with the installation, TURN OFF
THE POWER TO THE LIGHTING CIRCUIT AT
THE CIRCUIT BREAKER OR FUSE BOX TO
AVOID ELECTRICAL SHOCK.
CHOOSING A MOUNTING LOCATION &
WIRING REQUIREMENT
(1) Select a location for the unit either on a wall
or eaves at a height of 1.8~2M above the
ground to prevent tampering.
(2) Install a wall switch adjacent to the power
source. (FIGURE 1)
FIGURE 1
(3) Switch off the power source or wall switch.
(4) Remove the mounting bracket from the
floodlight. Drill the wall and screw the
bracket onto the wall using suitable plastic
wall plugs and screws.
Note: Do not at this stage re-attach the
floodlight to the bracket.
(5) Unscrew two screws at the rear of junction
box then remove junction's box back plate.
(6) Loosen two screws on the pressure block.
(FIGURE 2)
FIGURE 2
1