Panasonic SC-CMAX5 Operating Instructions Manual page 19

Messages
The following messages or service numbers
may appear on the unit's display.
"A NO DEV"
"B NO DEV"
≥ The USB device is not inserted correctly. Read
the instructions and try again (l 8).
"ADJUST CLOCK"
≥ Clock is not set. Adjust the clock accordingly.
"ADJUST TIMER"
≥ The play and/or record timer is not set. Adjust the
play and/or record timer accordingly.
"AUTO OFF" (blinks)
≥ The unit has been left unused for about 20
minutes and will shut down within a minute. Press
any button to cancel it.
"CAN'T REC"
≥ You cannot do recording when the USB device is
locked. Unlock the USB device and try again.
"DEVICE FULL"
≥ You cannot do recording because the remaining
recording time of the USB device is less than the
total time of the music source. Change to a USB
device which has enough recording time and do
the recording again.
"ERROR"
≥ Incorrect operation is performed. Read the
instructions and try again.
"ERROR" (during recording)
≥ You cannot select other playback source
(e.g.: USB etc.) or press [:/6] or [5/9]
during recording. Stop the recording function.
"F " (" " stands for a number.)
≥ There is a problem with this unit.
≥ Write down the displayed number, disconnect the
AC mains lead and consult your dealer.
"GUITAR SWITCH ON"
≥ You cannot use the Karaoke function when
[B MIC C ] is at the pushed-down position.
Change it to the released position. (l 16)
"INVALID"
≥ You cannot select the vocal cancel, echo and key
control when the Karaoke mode is off.
Press [KARAOKE] on the unit to select "ON
KARAOKE". (l 16)
"NO PLAY"
"UNSUPPORT"
≥ Examine the content. You can only play
supported format. (l 3)
≥ The files in the USB device can be corrupted.
Format the USB device and try again.
≥ The unit may have a problem. Turn the unit off
and then on again.
"NO TRACK"
≥ There is no album or track in the USB device.
"PLAYERROR"
≥ You played an unsupported MP3 file. The system
will skip that track and play the next one.
"REC ERROR"
≥ You disconnected the USB device while
recording. Connect the USB device and do
recording again.
"REMOTE " (" " stands for a number.)
≥ The remote control and this unit are using
different codes. Change the code on the remote
control.
– When "REMOTE 1" is displayed, press and hold
[OK] and [ ] on the remote control for at least
4 seconds.
– When "REMOTE 2" is displayed, press and hold
[OK] and [USB] on the remote control for at least
4 seconds.
"TEMP NG"
≥ The temperature protection circuit has been
activated, and the system will switch off. Let the
unit cool down before switching it on again.
≥ Check that the ventilation opening of the unit is
not obstructed.
≥ Ensure this unit is well ventilated.
"USB OVER CURRENT ERROR"
≥ The USB device is drawing too much power.
Remove the USB device and turn the unit off.
"VBR"
≥ The system cannot show the remaining play time
for variable bit rate (VBR) tracks.
19
19
RQT9961