INSTALLATION Installing / replacing the lamp DANGER TO LIFE Only install the lamp with the device switched off! Unplug from mains before! For the installation, you need one 189W fast fit lamp Protection gloves, helmet with sight, leather apron. CAUTION! The lamp has to be replaced when it is damage or deformed due to the heat! ●...
Page 3
Rigging DANGER TO LIFE! Please consider the respective national norms during the installation! The installation must only be carried out by an authorized dealer! ● The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight for 1 hour without any harming deformation.
Page 4
● For overhead use, always install a safety rope that can hold at least 12 times the weight of the fixture, you must only use safety ropes with screw on cardinal. Pull the safety rope through the hole on the bottom of the base and over the trussing system etc. insert the end on the cardinal and tighten the fixation screws.
OPERATION ● After you connected the effect to the mains, this moving-head light starts running. During the reset, the motors are trimmed and the device is ready for use afterwards. ● You can control the projectors individually via you DMX-controller, Every DMX-channel has a different occupation with different features, in order to all up the different features.
Page 11
Maintenance 1. To reduce the risk of electrical shock of fire, do not expose this unit to rain or moisture. 2. Do not spill water or other liquids into or on to your unit. 3. During long periods of non-use, disconnect the unit’s main power. 4.
Need help?
Do you have a question about the Beam200W Titanium PRO and is the answer not in the manual?
Questions and answers