Honeywell HZ-420 series User Manual page 5

OPeraTiON
(cONTiNUeD)
To set the heater, the digital control is equipped with two (2) modes:
constant Heat - there are two (2) heat settings
1. For Constant Low, press (
2. For Constant High, press (
NOTE: Because the Low (
efficient and may be a better option if you are concerned about saving energy.
energySmart mode -
™
A smart thermostat that helps you save energy. Press SET to choose four (4) comfort settings of 65° (18°),
70° (21°), 75° (24°), 80° (27°). This is your desired room temperature. The EnergySmart™ thermostat
will automatically select the appropriate power level to best accommodate your Desired Temperature.
As the air temperature (Current Temp) in the room approaches the Desired Temperature, the heater will
automatically lower the power consumption to provide consistent warmth without wasting energy.
The Current Temp Indicator will display the current room temperature.
NOTE: In the EnergySmart™ mode, the Energy Usage Indicator will display what power consumption the
heater has automatically selected to efficiently meet your Desired Temperature.
• To override the EnergySmart™ function, turn the heater OFF (
Constant Heat mode. The Energy Usage guide will indicate STAND BY when the heater has reached
the Desired Room Temperature. At this point, the heater is most efficient and is drawing only a few
watts of energy while in STAND BY mode.
• To set the Timer, press the (
that chosen period in the selected mode, counting down the remaining time in the display bar and
automatically shut off after the desired time has passed.
model HZ-440 Series - Digital 360º Surround Heater with remote Operation
Turn heater on by pressing Power Button on (
and the heater will start at the Hi Heat Level
Setting ( ). The Desired Temperature will flash
three times at a default of 75°F and the Current
Temperature in the room will then display in steady
red. Note: if the Current Temperature is higher
than 75°, the heater will remain off until the room
temperature falls below this setting or until the
Desired Temperature is changed.
• To set the Heat Level, press (
1. For Low, (
900 watts of power
2. For High, (
1500 watts of power
Note: Because the Low (
not require as much electricity to operate,
it is more energy efficient and may be a
better option if you are concerned about
saving energy.
); this setting uses 900 watts of power
); this setting uses 1500 watts of power
) setting does not require as much electricity to operate, it is more energy
) button to select 1, 2, 4, or 8 hour setting. The heater will run for
):
); this setting uses
); this setting uses
) setting does
)
model HZ-440
Current Temperature/
Desired Temperature
Display
Temperature
Set Button
Timer
Heat Level
Setting
Power Button
Power Light
) or press SET to choose a
5