Paper Out Detector - Panasonic KX-P3200 Operating Instructions Manual

Llsing the Control Panel and DIP Switch
, '" J
~
Top of Form Function (TOF SET)
This printer has a Top of Form (TO F) function which stores the first print line pOSition and loads the paper to the
designated position automatically The first pnnt line position Will be stored even after the power IS turned off
You can adjust the Top of Form position by uSing the Control Panel Software program
(1&
P 13), or uSing Micro
Line Feed or Reverse Micro Line Feed from the Control Panel within 5" from the top of your paper
1
Note:
• Do not rotate the platen knob, otherWise the printer Will not be able to count the number of lines properly
• All adjustments must be made on the first sheet If you deCide to change the setting and save It, remove the
paper from the tractors, then reset and reload the paper
If necessary, redefine the page length of the paper you are uSing through the Control Panel Software
program (
1&
P 13-14), Control Panel (
1&
P 18) or your application software.
2
(Micro Line Feed)
3
o
0
I
FONT
I
1::1-
READY
(Reverse Micro Line Feed)
1::1- READY
1::1-
LF/FF
LOAD
•
•
While pressing (READY), press (FONT).
ThiS advances the paper one micro line
(1;216")
While pressing (READY) ,press (LF/FF) .
ThiS reverse the paper one micro line
(1;216")
The printer cannot reverse the paper past the printable
area (
1&
P 25 Printing Area)
At your desired position within 5" from the top of your paper, release the sWitches
The paper position Will be stored automatically as the new Top of Form position
Paper Out Detector
Your printer has a paper out detector When an out of paper condition occurs, printing stops, the READY indicator
goes off (If the printer stili has data, the READY Indicator starts blinking), and the PAPER OUT Indicator starts
blinking To continue printing to the end of the current page, follow the steps below
1 Press (READY) repeatedly until the page IS
I
2
completed.
Note:
Insert the new paper and press ( LOAD)
(1&
P 9).
• When PAPER OUT DETECT IS set to ON, printing stops at 0 5" from the bottom of the paper
• The paper out detector can be disabled through the Control Panel Software program
(1&
P 13)
17
c
!!!.
:::I
(Q
~
ID
o
o
:::I
-
a
'tJ
QI
:::I
~