Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for 4load Charge Box 7.0
Summary of Contents for 4load Charge Box 7.0
- Page 1 CHARGE BOX 7.0 BATTERY-CHARGER 7,0 AMP USER MANUAL WWW.4LOAD.DE WWW.4LOAD.DE...
-
Page 3: Table Of Contents
Table of Content Introduction For your safety ...................Page 14 Intended use ....................Page 14 Scope of delivery..................Page 14 Description of parts ..................Page 14 Technical data ....................Page 15 Safety Safety information ..................Page 15 Properties ....................Page 16 Before starting device up for the first time ........Page 17 Operation Connection ....................Page 17... -
Page 4: Introduction
Introduction The following pictogrammes / symbols are used in these operating instructions: Read the operating instructions! Watts (effective power) Always heed warning labels and Volt (AC) safety instructions! A/Ah/ Caution - Danger of electric shock! Amps / Amp-hours / Milliamps Hazardous voltage –... -
Page 5: Technical Data
Introduction / Safety ** = Noise figure is the nuisance value of the current r Power cable with mains plug t Charging cable with 12 V plug and voltage. y “+”-pole connecting cable ring terminal (red) u “–”-pole connecting cable ring terminal (black) Safety i “+”-pole alligator clip (red) o “–”-pole alligator clip (black) -
Page 6: Properties
Safety Wear protective goggles! negative (minus) pole (black) of the charger Wear protective gloves! from the negative (minus) pole of the battery. If your eyes or skin come into contact with sul- Always turn your face away from the battery when phuric acid, rinse the affected part of the body you connect the charging cable to the battery. -
Page 7: Before Starting Device Up For The First Time
Before starting device up for the first time / Operation Before starting device up You can choose between the following modes for the first time of operation: Clean the battery clips. Make sure that your Mode 1 28.8 V (24 V / 3.5 A): eyes do not come into contact with rust. -
Page 8: State Of Charge
Operation for the state-of-charge also comes on (see “State The LED for Mode 4 O lights up. As soon as the of charge”). The charging process starts with integrated switch is thrown, the appropriate LED an amperage of 7 A. As soon as the battery has for the state-of-charge also comes on (see “State been fully charged (14.4 V), the following LEDs of charge”). -
Page 9: Regeneration Mode (16 V Boost)
Operation / Maintenance Regeneration mode (16 V BOOST) mode. If you do not input any other setting, the system will remain on STANDBY. With reversed polarity, the Note: This mode is only suitable for 12 V batteries. “Error” Q will light up. This way, the sparks Note: In this mode, the batteries have to be charged that often arise during the connection process are fully! -
Page 10: Disposal
Disposal / Information Disposal The packaging is wholly composed of environmentally-friendly materials that can be disposed of at a local recycling centre. Do not dispose of electrical appliances in household waste. Information Servicing Have your device repaired only by quali- fied specialist personnel using original manufacturer parts only. - Page 11 4 Load GmbH Glendale Str. 4 87700 Memmingen Germany www.4load.de...
Need help?
Do you have a question about the Charge Box 7.0 and is the answer not in the manual?
Questions and answers