Advertisement
PARTS LIST
PART #
DESCRIPTION
A
Heater Body
B
Heater Brace
C
Tighting Screw
D
Wire Loop
E
ON/OFF Switch
F
Locking Pin
A
F
C
E
1. Make sure that all the parts are present and that there are no missing parts. Please empty the
carton thoroughtly to make sure after unpacking the unit from the box.
2. DO NOT PLUG THE UNIT IN UNTIL THE UNIT IS COMPETELY ASSEMBLED ON THE UMBRELLA AND
THERE IS NO DAMAGE TO THE UNIT AND POWER CORD.
NOTE: This product is intended for residential, non-commercial use.
QUANTITY
1
1
1
3
1
3
C
B
D
3
ASSEMBLY INSTRUCTIONS
1. (SEE FIGURE 1) Remove the heater brace (B)
from the heater body (A) by sliding it downward.
2. (SEE FIGURE 2) Place the heaterbody (A) onto an
umbrella pole between 1" (25mm) - 2.4" (60mm)
diameter by inserting the pole into the slot
on the heater body (A).
3. (SEE FIGURE 3) Place the heater brace (B) back
on by sliding it upward. Secure the heater to
the umbrella pole by turning the tighting
screw (C) clockwise until the heater is secure
on the umbrella pole.
4. (SEE FIGURE 4) Using the wire loop (D) at the
end of the heater panel pull the heater panel
up until a click is heard. Repeat with the other
two panels. This means the panel is now
locked into position.
CAUTION: DO NOT FOLD THE PANELS DOWN
WITHOUT FIRST PUSHING THE LOCKING PIN IN.
5. (SEE FIGURE 4) To fold any of the panels down,
press the metal locking pin at the hinge of the
heater panel, then holding onto the wire loop (D)
at the front end of panel, fold the panel down.
NOTE: WAIT UNTIL THE HEATER PANELS HAVE ALL
COOLED OFF BEFORE FOLDING THE PANELS
DOWN. When any of the heater panels are folded
down while the unit is on, that panel will shut-off.
On back of each panel is a shut-off switch so
that only two or even one heater panel can be
used instead of all three.
Figure 1
A
B
Figure 2
Pole
A
Figure 3
C
Figure 4
F
D
4
B
Advertisement
