SPECIFICATIONS
Dimensions:
Weight:
Frequency Bands:
Signal Meter
Frequency Response:
switch between your cable feed and over-the-air signals
from your JACK antenna.
To use the Power Injector, simply turn the unit on with the
ON/OFF button. When on (button depressed), the power
light will turn green indicating +12 volts to the antenna,
and the over-the-air signal from your JACK antenna will
be fed to the two TV outputs.
When off, the cable TV signal will be fed to the two TV
outputs if wired for cable TV input.
1. Turn on antenna power at Power Injector Wall Mount Plate.
2. Turn on SureLock Signal Meter with switch on side of rotational knob enclosure.
3. Rotate attenuator dial fully clockwise.
NOTE: In step 4, LED lights will illuminate from left (next to power) to right.
All LED lights may not illuminate depending on signal strength.
4. Depress button on rotational knob and rotate antenna
until maximum number of LED lights illuminate on signal meter.
5. Rotate attenuator dial counter clockwise until last illuminated LED light flickers.
6. Rotate antenna to illuminate last flickering LED light.
7. Repeat steps 5 and 6 to pinpoint signal reception.
8. Follow instructions for TV or converter box to scan for available channels.
JACK
®
w/built-in SureLock
11.25" H x 16" W x 12.5" L
2.3 lbs.
VHF (47-230 Mhz) - 20 db gain
UHF (470-860 Mhz) - 25 db gain
40-862 Mhz (Ch 2-69)
POSITIONING THE ANTENNA
Digital HDTV Over-the-Air Antenna
®
OA8200 - White • OA8201 - Black
Powered Amplifier:
Power Supply:
Enclosure/Mount:
OPERATION
Page 1
Digital TV Signal Meter
+12 Volt / 100 mA working
Wall Mt. Switch (included)
• Mfr. # PB1000 - power supply, white
ASA-Automotive grade
NOTE: Arrow on knob indicates which
direction antenna is pointing.