Preview Preco X32-6-C PreView Quick Installation Manual

X32-6-C PreView
QUICK INSTALLATION GUIDE
1 Before You Start
Contents:
XPV4232A-6 Sensor (1)
Sensor Mounting Hardware (1)
Cables (4)
XPV41CA Cable (1), XPV41PA Cable 1'/0.3M (1)
XPV4132 32.8'/10.0M (1), XPV41RA Cable 3.3'/1M (1)
CD6 Display(1)
Display Mounting Hardware
User Manual
Sensor
Hardware
Note orientation:
THIS SIDE UP
XPV4232A-6
XPV41RA
DOC. # 3700143D
™
System
2
Select a location for the sensor approximately 3ft/1M from the ground.
Ideally the sensor should be centered on the rear of the vehicle.
Before the PreView Sensor is permanently installed to the vehicle,
verify the selected location provides a clear detection zone.
Temporarily attach the sensor in the proposed location, apply power to
the system, and verify nothing is detected.
The sensor may be mounted directly on the vehicle or attached using a
bracket. Using the drill template, scribe position marks through the holes
and drill 1/4" (6mm) holes centered at the marks. A 1 1/2" diameter
clearance hole is required for the sensor connector and the mating cable.
Secure the sensor to the vehicle with the supplied hardware. Apply a
maximum of 50 in-lbs to secure the sensor.
Not all hardware shown
XPV41PA
XPV41CA
XPV4132
Mount Sensor
Important!
Mounting
DISPLAY
HARDWARE
CD6
1
3 Install Cables
Routing the body harness should start at the rear of the vehicle and end in the cab. To
enter the cab, drill a 1 1/2" (38mm) hole and feed the connector through to connect to
the cab adapter.
Important!
The sensor mating connector is fully waterproof if mated properly.
connectors with a collar (coupling ring) must be turned to the right until
they lock with the mating connector. Latch(es) on mating connector
must click (locking connectors together).
sources or area that may see abrasion or rock and debris damage. Bundle and
store any excess cable.
4 Mount Display
Mount the display in a location easily viewed by the driver. Possible locations for the
display is on the dash or by either windshield pillar.
Wire Connections
Wiring Diagram
Contact Technical Support with Questions:
Telephone: 844.787.2327
Web: www.PreViewRadar.com
Email: support@preco.com
The quick install guide is only a supplement to the product manuals. Please read all of the
manuals for complete information and instructions before installing the product.
10335 W Emerald St 10335 W Emerald St
Powered by Powered by
Boise, ID 83704 Boise, ID 83704
Phone 1.208.323.1000 Phone 1.208.323.1000
The
Do not route cable next to heat
Back Page