Husky Storm Model; Installation; Power Unit - Husky STORM User Manual

3. HUSKY STORM MODEL

Air Intake
Control module
with soft-start
and LED status
indicator
Machine washable
permanent lter
Brushed aluminium
canister

4. INSTALLATION

POWER UNIT

Mounting the unit on the wall.
Fig. 1
The power unit must be installed in a ventilated area, easily accessible and away from any heat
source. It should also be close to an accessible electrical outlet.
Determine the location of the power unit on the wall; we recommend that the power unit
1�
be fastened at 60" / 1,5 m from the ground in order for the dust canister to be readily
accessible; allow 12" / 30 cm clearance on all sides of the power unit. When possible, it is
6 | DOC-575_EN REV01
Air outlet
Integrated
handle / latch
Disposable ltration bag
(optional)
NOTE
» in order to avoid overheating, we recommend 12 in / 30 cm
clearance all around the power unit.
advisable to install the power unit on a concrete wall in order to minimise the vibrations;
Gypsum wall:
2�
• Prepare the wall by installing a plywood mounting board (not provided) 16" / 40 cm
high x 3/4" / 2 cm thick and wide enough to be screwed to at least 2 studs;
• Fasten the mounting bracket to the mounting board with the provided screws;
Concrete wall:
3�
• Drill the holes with a concrete drill bit;
• Insert the provided wall anchors into the drilled holes;
• install the mounting bracket with the provided screws into the anchors;
NOTE
» You can still install a plywood mounting (16" / 40 cm x 10" / 25 cm x
3/4" / 2 cm) board if desired;
» You can use provided screws to fi x mounting board on the wall, but
cannot use them for installing the mounting bracket on the mounting
board because of their length. You need to use shorter screws (not
provided).
IMPORTANT
Always use the right type of screws for the surface you are working with (wood,
concrete, metal...)
Insert the power unit bracket into the mounting bracket (Fig. 1).
4�
Insert the PVC pipe into the air intake coupling; DO NOT GLUE!
5�
Connect the controller module as explained in section 6;
6�
Connect the power unit directly into an electrical outlet.
7�