Advertisement
10. Connect the other end of the small
diameter suction hose (43 mm
(13) to the blade guard.
13
14
11. Hang the small diameter suction
hose to the support bracket (14).
12. Connect the long suction hose
(100 mm
(15) to the planer/thick-
nesser's suction port.
13. Put handle (16) on the selector and
secure with screw.
14. Bend the spring steel ring of the
dust bag (17) inward and fit inside
the receiver (18), up against the
stop.
17
15. Plug the dust collector's short cable
into the left outlet (19) of the dust
collector.
19
20
15
16. Connect the combination machine's
power cable plug to the right outlet
(20) of the dust collector.
17. Connect the long power cable to a
mains outlet.
16
4. Operation
Commissioning
1.
Set the selector:
Selector in upper position:
collection for circular saw and
spindle moulder.
Selector in lower position:
collection for planer/thicknesser.
2.
Start dust collector.
3.
Start woodworking machine.
Stopping
1.
Switch woodworking machine OFF.
2.
Switch dust collector OFF.
Relocation
1.
Pull handle (21) out.
18
2.
With the handle lift the complete
unit, until the wheels touch the floor.
3.
Roll unit to the desired location.
5. Maintenance
Check the dust bag periodically.
If the dust bag is filled:
1.
Unplug the dust collector.
2.
Open the service door.
3.
Push the spring steel ring inward
and remove the dust bag from the
receiver.
4.
Dispose of the dust bag's contents
in an ecologically safe way.
5.
Replace the dust bag (see Assem-
bly) and close the service door.
6. Technical Specifications
Power supply
Power input P
:
1
Power output P
Total power input P
(when operated with Combination
machine Multi 180A):
Mains fuse:
Degree of protection:
Suction capacity:
Vacuum:
Dust bag capacity:
Suction port Ø: 2 x 100 mm / 1 x 43 mm
Dimensions (L x W x H):
Weight:
Noise emission:
see combination machine
ENGLISH
21
230 V / 1 ~ 50 Hz
0.62 kW
:
0.37 kW
2
1
1.72 kW
16 A, time-lag
IP 44
3
600 m
/h
1000 Pa
68 litres
760 x 760 x 500 mm
48 kg
5
Advertisement
