Advertisement
Available languages
Available languages
CAT5 MULTI VIDEO SYSTEM
1.Specifications
Cable Required: Between transmitter and receiver(s): Category 5 shielded or
unshielded twisted pair (STP or UTP)
Compliance:
CE; FCC Class A, IC Class/classe A
Video Support: Transparent to users—transmitter/receiver dependent.
Resolution and
Refresh Rate:
2048 x 1536 @ 70 Hz, SD and HDTV formats (480i, 480p, 525p,
720p, 1080i, 1080p) — transmitter/receiver dependent
Transmission: Transparent to users (automatic, no delay)
Maximum
Distance:
Total end to end, from source device to farthest destination
device, over good CAT5 cable (assuming source
outputs signal at normal strength) receiver dependent:
Up to 1500 ft. ( 457m) all resolutions
Connectors:
AC1050A: (1) RJ-45 input, (9) RJ-45 ouput;
(1) rear-mounted 5-pin DIN F power inlet
Temperature
Tolerance:
Operating: 32 to 104°F (0 to 40°C);
Storage: -4 to +140°F (-20 to +60°C)
Humidity
Tolerance:
Up to 80% noncondensing
Enclosure:
Steel
Power:
From utility-power (mains) outlet to power inlet, through
detachable external power supply: Input: 100 to 250 VAC
@ 50 or 60 Hz (autosensing);
Output: +5 VDC;
Consumption: 12 watts maximum
Size:
1.75"H x 8.1"W x 6.5"D (4.5 x 20.6 x 16.5 cm);
Weight:
2.3 lb. (1.0 kg);
4
6
2. Introduction
2.1 Overview
The CAT5 Multi Video System extends video signals over ordinary Category 5
cable. All models use a transmitter-to-receiver setup.
This manual covers the CAT5 Multi Video System 1x9 Distribution Amp. A CAT5
Multi Video System transmitter unit as well as CAT5 Multi Video System receiver
units are required for operation. Please contact technical support for help.
WARNING
This equipment is not intended for, nor does it support, distribution
through an Ethernet network. Do not connect these devices to any sort
of networking or telecommunications equipment!
2.2 Package Contents
You should have received the following when ordering a CAT5 Multi Video System
receiver:
•
The 1x9 Video Distribution Amp.
•
A ground wire.
•
External power supply (100–250 VAC, 50–60 Hz, autosensing) with cord.
•
This manual.
2.3 Equipment You May Also Need
•
CAT5 cable.
2.4 Compatible Cabling
CAT5 cabling for the CAT5 Multi Video System must be pinned to the TIA-EIA
T568B wiring specification. We also highly recommend that all CAT5 cables
be pre-terminated and tested. Cables terminated on-site or in an existing
infrastructure should be tested before use to ensure compliance with the TIA-EIA
T568B specification. Using incorrectly terminated CAT5 cables can damage the
CAT5 Multi Video System.
CHAPTER 2: Introduction
.
7
9
Advertisement
